J Thomas
2005-Mar-17 04:26 UTC
[Asterisk-Users] TE110p card with Euro ISDN (Ericsson switch)
I am trying to use TE110p card for Euro ISDN with Ericsson AMS switch. I consistently get one of the following errors: PRI got event: HDLC Abort (6) on Primary D-channel of span 1 or PRI got event: HDLC Bad FCS (8) on Primary D-channel of span 1 My zaptel.conf file: -------------------------------- span=1,0,0,ccs,hdb3,crc4 bchan=1-15,17-31 dchan=16 loadzone=us defaultzone=us -------------------------------- My partner and I have tried to find answer on google, IRC and even digium tech support but no luck so far :-( I observe the same behavior on FC3 as well as RH9, and on different hardware too. One of them is Intel Motherboard with 3 GHz P4 processor (FC3), the other is Supermicro with 2.4GHz Dual Xeon processor (RH9). Surprisingly, a similar machine with Supermicro motherboard works very well with TE405p card. I checked the interrupts etc. and there is no shared interrupt with the card. Hence I suspect the issue is at the signaling level or with the card's driver rather than some interrupts getting lost. I could be completely wrong though. Any help will be greatly appreciated. Thanks, -- jt
Jens Kübler
2005-Mar-17 05:22 UTC
[Asterisk-Users] TE110p card with Euro ISDN (Ericsson switch)
Am Donnerstag 17 M?rz 2005 12:26 schrieb J Thomas:> I am trying to use TE110p card for Euro ISDN with Ericsson AMS switch. I > consistently get one of the following errors: > > PRI got event: HDLC Abort (6) on Primary D-channel of span 1 > or > PRI got event: HDLC Bad FCS (8) on Primary D-channel of span 1 >Got the same problem here connecting a Siemens PBX cross via ETSI protocol but so far it seems not to cause any considerable errors for telephony service (still testing setup). Jens
Tony Mountifield
2005-Mar-19 10:48 UTC
[Asterisk-Users] Re: TE110p card with Euro ISDN (Ericsson switch)
In article <1111058806.6853.64.camel@homedell>, J Thomas <jthomas@cequip.com> wrote:> I am trying to use TE110p card for Euro ISDN with Ericsson AMS switch. I > consistently get one of the following errors: > > PRI got event: HDLC Abort (6) on Primary D-channel of span 1 > or > PRI got event: HDLC Bad FCS (8) on Primary D-channel of span 1 > > My zaptel.conf file: > -------------------------------- > span=1,0,0,ccs,hdb3,crc4Try: span=1,1,0,ccs,hdb3,crc4 That tells the card to take its signal timing from the remote end. Cheers Tony -- Tony Mountifield Work: tony@softins.co.uk - http://www.softins.co.uk Play: tony@mountifield.org - http://tony.mountifield.org