In a setup I've made i have a problem in the two way origination of the call. Asterisk 1 <==> Public internet <==> NAT <==> Asterisk 2 note the two way pointing arrows. When you call from the *2 to the *1, the call passes, but if you try to call from the *1 to the *2, it will not connect, unless you call from *1 to *2, and inmediately after hang-up, you call in the other way. I'm pretty sure it's a NAT loosing state too fast, and i can do nothing to fix the NAT. Is there a way to have a keep-alive between the two * boxes? I read about a config in iax.conf called qualify=yes to do that? does the qualify parameter activates a sort of keep-alive? Miguel Ruiz Velasco __________________________________ Do you Yahoo!? Take Yahoo! Mail with you! Get it on your mobile phone. http://mobile.yahoo.com/maildemo
On 11/01/2005 04:21 Miguel Ruiz Velasco Sobrino said the following:> In a setup I've made i have a problem in the two way origination of the call. > > Asterisk 1 <==> Public internet <==> NAT <==> Asterisk 2 > I'm pretty sure it's a NAT loosing state too fast, and i can do nothing to fix the NAT. > Is there a way to have a keep-alive between the two * boxes?have *2 register (via IAX2) with *1 and all should be fine. IAX2 works well thru NAT, unlike SIP/RTP. -- Regards, /\_/\ "All dogs go to heaven." dinesh@alphaque.com (0 0) http://www.alphaque.com/ +==========================----oOO--(_)--OOo----==========================+ | for a in past present future; do | | for b in clients employers associates relatives neighbours pets; do | | echo "The opinions here in no way reflect the opinions of my $a $b." | | done; done | +=========================================================================+