asterisk users - Oct 2004 - UK CallerID

Sometime ago I posted a query about CallerID not working on one of my analog
channels on my BT Home Highway ISDN.  It subsequently turns out that I only had
CallerID enabled on one of the analog numbers, not both.  Entirely my fault for
not checking both lines.

Now that CallerID is enabled on the second channel it works a treat.  Many
thanks to everyone who did the programming on this.

Presumably one can set the CallerID commands in zapata.conf on a per channel
basis, or is this a global setting?   Apologies if that is an elementary
question which I should already know.  If it is a global setting, then that
means you would not be able to enable CallerID if some of the lines are not
CallerID enabled.  (Asterisk won't answer a line if it is expecting CallerID
and it isn't enabled.)

Hi George,

Could you send me your ISDN config if possible.

I managed to get my new BT ISDN30 line working last night but wasn't
getting any incoming callerid.
I hoped this was because I only asked BT to enable CallerID yesterday
morning.

The ISDN is on a different site so its not easy for me to test at the
moment, hence why I would like to confident I have it setup correctly.

Thanks very much

Alex

-----Original Message-----
From: George Gardiner [mailto:asterisk@georgej.demon.co.uk] 
Sent: 27 October 2004 10:29
To: asterisk-users@lists.digium.com
Subject: [Asterisk-Users] UK CallerID



Sometime ago I posted a query about CallerID not working on one of my
analog channels on my BT Home Highway ISDN.  It subsequently turns out
that I only had CallerID enabled on one of the analog numbers, not both.
Entirely my fault for not checking both lines.

Now that CallerID is enabled on the second channel it works a treat.
Many thanks to everyone who did the programming on this.

Presumably one can set the CallerID commands in zapata.conf on a per
channel basis, or is this a global setting?   Apologies if that is an
elementary question which I should already know.  If it is a global
setting, then that means you would not be able to enable CallerID if
some of the lines are not CallerID enabled.  (Asterisk won't answer a
line if it is expecting CallerID and it isn't enabled.)


_______________________________________________
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users


This email and any attached files are confidential and copyright protected.  If
you are not the addressee, any dissemination, distribution or copying of this
communication is strictly prohibited.  Unless otherwise expressly agreed in
writing, nothing stated in this communication shall be legally binding.

Hi

There was recently an update to the X100P patches to support 1.2.

If you look at the Lusyn website I think he's covered it (It was on this
list about 2 weeks back).

P