asterisk users - May 2003 - Disconnect options for X100P card

Asterisk is running with a X100P card. When I connect a CO line to the
X100P card, the busy tone is detected and * disconnect the channel without
any problem. The disconnection problem occurs when instead of a CO line I
connect an analog extension from a Meridian Option 11 PBX. When The caller
hang-up, the X100P only receives a Dial tone no a busy tone. I would like to
know if there is an option to configure X100P in order that after receiving
a Dial tone for a specific period of time automatically disconnect the
channel.

Thanks

Check if you can enable "remote disconnection supervision" with your
PBX.
If not you may try using the software detection when you specify

callprogress=yes
or
busydetect=yes

before the definition of your channel in zapata.conf

Martin

On Wed, 28 May 2003, Manuel Marin Garcia wrote:
> 	Asterisk is running with a X100P card. When I connect a CO line to the
> X100P card, the busy tone is detected and * disconnect the channel without
> any problem. The disconnection problem occurs when instead of a CO line I
> connect an analog extension from a Meridian Option 11 PBX. When The caller
> hang-up, the X100P only receives a Dial tone no a busy tone. I would like
to
> know if there is an option to configure X100P in order that after receiving
> a Dial tone for a specific period of time automatically disconnect the
> channel.
>
> Thanks
>
>
>
>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users@lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>