John Todd
2003-Mar-11 18:41 UTC
Fwd: Re: [Asterisk-Users] Clarification (SIP Behind NAT question)
I shouldn't have spoken so quickly. I just tested an ATA-186 to verify what I had said in the negative, and I find that leaving the ConnectMode set to 0x00060400 (the default from the factory on v2.15) doesn't seem to make a difference - my ATA behind a NAT worked just fine. Go figure. JT>You may have read the earlier posts on it, but to make sure: you did >set ConnectMode to 0x00460400 right? Also, you have "nat=1" in the >settings for your ATA-186 in sip.conf? Both are required for >correct functionality as far as I've seen. > >(Note: I've got an ATA-186 on a public IP address connected to * now >with ConnectMode set to 0x00460400 with seemingly no adverse issues. >Can anyone else verify? This would be convenient for general >configuration for bulk roll-outs if both public and private >addressed ATA-186's can have the same settings.) > >JT > > >At 4:17 PM -0600 3/11/03, Matthew Farley wrote: >> >>After sending my most recent message, I realized that I did not word it >>clearly. In case of any confusion as to my configuration, my Asterisk >>machine has a public IP, and the ATA186 is behind a NAT firewall. My >>apologies for any confusion. >> >>-- >>Matthew Farley <asterisk@wheatstate.net> > > > >>On your Cisco ATA-186: >> >>Set your IP address information as usual (use DHCP, or static, >>whatever your site requires) >>UID0: [your UID] >>PWD0: [this UID's password] >>UseSIP: 1 >>SIPRegInterval: 240 >>GkOrProxy: [ip address of your Asterisk server] >>Gateway: [ip address of your Asterisk server] >>ConnectMode: 0x00460400 >>OutBoundProxy: [ip address of your Asterisk server] >