Linux Virtualization - May 2011 - KVM: Vlans not working with vlan hw rx acceleration

Hi,
Setup info:
(a) Using RHEL6 kvm. (b) Loaded driver on RHEL6 setup.
(c) Created 2 bridges on top of two interfaces.
(d) Assigned these bridges to 2 VMs.
(e) Created vlans in VMs.
Problem:
When vlan acceleration support is enabled in driver, traffic stops b/w VMs on
vlan interfaces inside virtual m/c.
Without, vlan acceleration, everything works fine.
Thanks,
Sucheta.

________________________________
This message and any attached documents contain information from QLogic
Corporation or its wholly-owned subsidiaries that may be confidential. If you
are not the intended recipient, you may not read, copy, distribute, or use this
information. If you have received this transmission in error, please notify the
sender immediately by reply e-mail and then delete this message.
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.linux-foundation.org/pipermail/virtualization/attachments/20110512/51857e0c/attachment.htm