asterisk users - Dec 2008 - help with DAHDI hangup on calling out.

I installed DAHDI (2.1.0.3) on a machine with asterisk 1.4.22 and libpri 
1.4.7

and I am getting the error:
    -- Requested transfer capability: 0x00 - SPEECH
    -- Called 23/317506XXXX
    -- Channel 0/23, span 1 got hangup, cause 99
    -- Hungup 'DAHDI/23-1'

on DIALING out. Calling in seems to work just fine.

Seems like everything is configured fine...

system.conf
span=1,0,0,esf,b8zs
bchan=18-23
dchan=24


chan_dahdi.conf

[channels]
signalling=pri_cpe
switchtype=national
echocancel=yes
echocancelwhenbridged=yes
echotraining=400
callerid=asreceived
context=smvoice-incoming
group=1
channel => 18-23

extensions.conf in use is :
exten => _XXXXXXXXXX,1,Dial(DAHDI/g1/${EXTEN})


lspci shows
TE205P dual span card 5.0v

What might be going on here? Everything was working with zaptel 1.4.5.1 
and asterisk 1.4.18 so my T1 is good.

Jerry

Jerry Geis wrote:
> I installed DAHDI (2.1.0.3) on a machine with asterisk 1.4.22 and libpri 
> 1.4.7
> 
> and I am getting the error:
>     -- Requested transfer capability: 0x00 - SPEECH
>     -- Called 23/317506XXXX
>     -- Channel 0/23, span 1 got hangup, cause 99
>     -- Hungup 'DAHDI/23-1'
> 
Hangup Cause 99 is:
====================================An Information Element or Parameter Does Not
Exist or is Not Implemented.

Indicates that the equipment sending this cause has received a message 
which includes information element(s)/parameter(s) not recognized 
because the information element identifier(s)/parameter name(s) are not 
defined or are defined but not implemented by the equipment sending the 
cause.
=====================================
I suspect your carrier has not configured your service to permit dialing 
out.

>
> Hangup Cause 99 is:
> ====================================> An Information Element or
Parameter Does Not Exist or is Not Implemented.
>
> Indicates that the equipment sending this cause has received a message 
> which includes information element(s)/parameter(s) not recognized 
> because the information element identifier(s)/parameter name(s) are not 
> defined or are defined but not implemented by the equipment sending the 
> cause.
> =====================================>
> I suspect your carrier has not configured your service to permit dialing 
> out.
>
>   
I actually upgraded from a working configuration for over a year that 
was using
asterisk 1.4.18 and libpri 1.4.1 and zaptel 1.4.5.1

So everything was working. I then put on asterisk 1.4.22, libpri 1.4.7 
and DAHDI 2.1.0
and this is when I get the cause 99.

So the T1 is configured correctly. I backed out back to the old config 
and its working again.
What do I do? I'd like to not be on a stale path and use the new DAHDI.

Jerry