sanchal.singh at alliance-infotech.com
2007-Aug-13 10:45 UTC
[asterisk-users] Does Digium TE120P card support MFCR2
Hi, I have successfully configured DIGIUM card and successfully communicated through it to the another E1 card running application. Can anybody tell me does TE120P support MFC/R2 protocol. Thanks and Regards sanchal singh
Matthew Fredrickson
2007-Aug-13 16:46 UTC
[asterisk-users] Does Digium TE120P card support MFCR2
sanchal.singh at alliance-infotech.com wrote:> Hi, > I have successfully configured DIGIUM card and successfully communicated > through it to the another E1 card running application. Can anybody tell me > does TE120P > support MFC/R2 protocol.Zaptel drivers are designed to be protocol independent. The TE120P should work with any protocol that any other T1/E1 zaptel card supports. -- Matthew Fredrickson Software/Firmware Engineer Digium, Inc.
On Mon, 2007-08-13 at 16:15 +0530, sanchal.singh at alliance-infotech.com wrote:> Hi, > I have successfully configured DIGIUM card and successfully communicated > through it to the another E1 card running application. Can anybody tell me > does TE120P support MFC/R2 protocol.As far as I know the card is not the issue. But you need to install additional software. Basically you need spandsp, libunicall, libmfcr2, libsupertone and chan_unicall from http://www.soft-switch.org If you use RHEL or CentOS then you can find a set of Asterisk 1.2 SRPMs that support this already at: http://www.laimbock.com/dl/asterisk/ You will need to rebuild the SRPMs with the options enabled that you require. Have a look in zaptel.spec and asterisk.spec. Regards, Patrick (remove -list from my email address if you want to reply privately)