Hi.. I have one intel 536 EP. Does it possible use it as x100p clone for asterisk? I tried today with no luck :(.. Here is what I did : - plugged the card the card is recognised as (lspci -vv): 00:09.0 Communication controller: Intel Corp. 536EP Data Fax Modem Subsystem: Intel Corp.: Unknown device 1000 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32, Cache Line Size 08 Interrupt: pin A routed to IRQ 12 Region 0: Memory at e2000000 (32-bit, non-prefetchable) [size=4M] Capabilities: [e0] Power Management version 2 Flags: PMEClk- DSI- D1- D2+ AuxCurrent=375mA PME(D0-,D1-,D2+,D3hot+,D3cold-) Status: D0 PME-Enable+ DSel=0 DScale=0 PME- - make and make install zaptel driver - modprobe zaptel (there's no output) - modprobe wcfxo and get these following messages: ZT_CHANCONFIG failed on channel 1: No such device or address (6) FATAL: Error running install command for wcfxo Is there any possibilities using this card with asterisk? I've searched wiki and there I found that people are success using Intel 537EP as x100p clone. While mine is merely Intel 536EP, but I think both are modems made by Intel.. Maybe there's a way making it function like x100p too like someone in asterisk channel (irc) told me :).. Thanks.. Regards, Stevanus