asterisk users - May 2004 - Error when loading wcfxo

I found similar posts regarding this error but none that answered my
question.

 

My zaptel.conf reads: 

 

fxsks=1-2

fxoks=3

loadzone=us

defaultzone=us

 

and /proc/interrupts:

           CPU0

  0:    5542402    IO-APIC-edge  timer

  1:          2    IO-APIC-edge  keyboard

  2:          0          XT-PIC  cascade

  8:          3    IO-APIC-edge  rtc

 14:      72582    IO-APIC-edge  ide0

 16:      81197   IO-APIC-level  eth0

 17:   54874555   IO-APIC-level  wcfxo

 20:   54874082   IO-APIC-level  wcfxo

 22:   54174464   IO-APIC-level  wctdm

NMI:          0

LOC:    5542842

ERR:          0

MIS:          0

 

 

 

When I run modprobe wcfxo I get the following error:

 

ZT_CHANCONFIG failed on channel 3: No such device or address (6)

/lib/modules/2.4.26/misc/wcfxo.o: post-install wcfxo failed

/lib/modules/2.4.26/misc/wcfxo.o: insmod wcfxo failed

 

 

After running modprobe wcfxs, the asterisk machine runs fine and ztcfg
doesn't complain.  

 

I tried moving cards to different slots but the error didn't go away.

If I remark out the fxoks=3 line the error goes away

If I reverse the load order in zaptel.conf and fire up the zaptel
modules (in reverse), I stop getting the error.  

 

So my question is why does the wcfxo try to fire up my TDM400 and is
this error a problem?

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.digium.com/pipermail/asterisk-users/attachments/20040504/9e20b15f/attachment.htm

On Tue, 4 May 2004, Marc Spiegelman wrote:
> When I run modprobe wcfxo I get the following error:
> 
> ZT_CHANCONFIG failed on channel 3: No such device or address (6)
> /lib/modules/2.4.26/misc/wcfxo.o: post-install wcfxo failed
> /lib/modules/2.4.26/misc/wcfxo.o: insmod wcfxo failed
> 
Check your /etc/modules.conf for the "post-install" lines.  The *
installation process adds these lines so that ztcfg is automatically run
after each of the modules is installed.  Remove all but the one for wcfxs
(I'm guessing that you insmod wcfxs last), or if you are used to running
ztcfg yourself after the modules are in just delete them all.

Cheers,
Vic Cross