Hi..
I have one intel 536 EP. Does it possible use it as x100p clone for
asterisk? I tried today with no luck :(..
Here is what I did :
- plugged the card
the card is recognised as (lspci -vv):
00:09.0 Communication controller: Intel Corp. 536EP Data Fax Modem
Subsystem: Intel Corp.: Unknown device 1000
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 32, Cache Line Size 08
Interrupt: pin A routed to IRQ 12
Region 0: Memory at e2000000 (32-bit, non-prefetchable) [size=4M]
Capabilities: [e0] Power Management version 2
Flags: PMEClk- DSI- D1- D2+ AuxCurrent=375mA
PME(D0-,D1-,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable+ DSel=0 DScale=0 PME-
- make and make install zaptel driver
- modprobe zaptel (there's no output)
- modprobe wcfxo and get these following messages:
ZT_CHANCONFIG failed on channel 1: No such device or address (6)
FATAL: Error running install command for wcfxo
Is there any possibilities using this card with asterisk?
I've searched wiki and there I found that people are success using Intel
537EP as x100p clone.
While mine is merely Intel 536EP, but I think both are modems made by
Intel..
Maybe there's a way making it function like x100p too like someone in
asterisk channel (irc) told me :)..
Thanks..
Regards,
Stevanus
