On Thu, Nov 25, 2021 at 10:58:56PM +0100, Marcel Holtmann
wrote:> Hi Michael,
>
> >>>>> Device removal is clearly out of virtio spec: it
attempts to remove
> >>>>> unused buffers from a VQ before invoking device reset.
To fix, make
> >>>>> open/close NOPs and do all cleanup/setup in
probe/remove.
> >>>>
> >>>> so the virtbt_{open,close} as NOP is not really what a
driver is suppose
> >>>> to be doing. These are transport enable/disable callbacks
from the BT
> >>>> Core towards the driver. It maps to a device being
enabled/disabled by
> >>>> something like bluetoothd for example. So if disabled, I
expect that no
> >>>> resources/queues are in use.
> >>>>
> >>>> Maybe I misunderstand the virtio spec in that regard, but
I would like
> >>>> to keep this fundamental concept of a Bluetooth driver. It
does work
> >>>> with all other transports like USB, SDIO, UART etc.
> >>>>
> >>>>> The cost here is a single skb wasted on an unused bt
device - which
> >>>>> seems modest.
> >>>>
> >>>> There should be no buffer used if the device is powered
off. We also don?t
> >>>> have any USB URBs in-flight if the transport is not
active.
> >>>>
> >>>>> NB: with this fix in place driver still suffers from a
race condition if
> >>>>> an interrupt triggers while device is being reset.
Work on a fix for
> >>>>> that issue is in progress.
> >>>>
> >>>> In the virtbt_close() callback we should deactivate all
interrupts.
> >>>>
> >>>
> >>> If you want to do that then device has to be reset on close,
> >>> and fully reinitialized on open.
> >>> Can you work on a patch like that?
> >>> Given I don't have the device such a rework is probably
more
> >>> than I can undertake.
> >>
> >> so you mean move virtio_find_vqs() into virtbt_open() and
del_vqs() into
> >> virtbt_close()?
> >
> > And reset before del_vqs.
> >
> >> Or is there are way to set up the queues without starting them?
> >>
> >> However I am failing to understand your initial concern, we do
reset()
> >> before del_vqs() in virtbt_remove(). Should we be doing something
different
> >> in virtbt_close() other than virtqueue_detach_unused_buf(). Why
would I
> >> keep buffers attached if they are not used.
> >>
> >
> > They are not used at that point but until device is reset can use
them.
> > Also, if you then proceed to open without a reset, and kick,
> > device will start by processing the original buffers, crashing
> > or corrupting memory.
>
> so the only valid usage is like this:
>
> vdev->config->reset(vdev);
>
> while ((.. = virtqueue_detach_unused_buf(vq))) {
> }
>
> vdev->config->del_vqs(vdev);
>
> If I make virtbt_{open,close} a NOP, then I keep adding an extra SKB to
inbuf on
> every power cycle (ifup/ifdown).
So make sure you don't :)
> How does netdev handle this?
>
> Regards
>
> Marcel
For net, open adds buffers to vq. close does not free them up -
they stay in the vq until device is removed.
--
MST