similar to: Problems reading a backup data DVD

Hi All, I had to reboot a machine as I lost the ssh connectivity to it. I could ping to it though. On rebooting, the dmesg buffer showed the following messsage hdc: dma_intr: status=0x51 { DriveReady SeekComplete Error } hdc: dma_intr: error=0x40 { UncorrectableError }, CHS=7520/0/155, sector=1820440 end_request: I/O error, dev 16:02 (hdc), sector 1820440 hdc: dma_intr: status=0x51 { DriveReady

Hi Gang. I installed CentOS last night and the sound card detection failled to detect the sound card. I have a Asrock K8NF6G-VSTA mother board, with a nVidia NF6100-405 chip set. I have tried various live distro's and I ran Fedora 7 on it for just over 2 weeks and none of them detected the sound card. I'm a newbie to Red Hat based distributions but have been using Mandriva for

Hi Gang. I installed CentOS last night and the sound card detection failled to detect the sound card. I have a Asrock K8NF6G-VSTA mother board, with a nVidia NF6100-405 chip set. I have tried various live distro's and I ran Fedora 7 on it for just over 2 weeks and none of them detected the sound card. I'm a newbie to Red Hat based distributions but have been using Mandriva for

Hi, Sorry if this is an old and fixed issue but I can't really seem to find a definitive explanation/fix to this in the mail lists. Ever since I upgraded to FC2 my server randomly decides that it can no longer access the disk and "aborts" the ext3 journal leaving it read-only as expected. I've seen the same errors on other mail list, explained away as disk or disk cable

Hello all. I'm using RedHat 7.2 now and haven't have any problems until today. I can still boot into the system at this time, but cannot load X at all. I'm getting the following error message when I try to run fsck. /contains a file system with errors, check forced. Pass 1: Checking inodes, blocks and sizes Error reading block 1277964 (Attempt to read block from filesystem resulted

Hi, I get the below from dmesg. The server seems to run fine, but it does worry me. What should I do? Other than take a backup.. :-) hda: dma_timer_expiry: dma status == 0x21 hda: DMA timeout error hda: dma timeout error: status=0xd0 { Busy } ide: failed opcode was: unknown hda: DMA disabled ide0: reset: success hda: dma_timer_expiry: dma status == 0x21 hda: dma_intr: status=0x51 { DriveReady

Hello everyone, I''m hoping to find an answer to my problem here. Currently I''m installing xen 2.0.7 on 30 dual opteron machines with 4GB memory. The machines have Tyan K8SR as motherboard with Silicon Image 3114 chip sata controler and 2 x 300 GB Western Digital SATA drives. Each xen server has 5 domUs, where some of them have high traffic and thus require high disk usage.

now that i am done ranting. i have a question. I received this error today and i think it was today only so far, but the error is as follows. hda: drive_cmd: status=0x51 { DriveReady SeekComplete Error } hda: drive_cmd: error=0x04Aborted Command i did some googling and found some stuff...but some said go out and get another drive this one is going to hard drive heaven very soon... and other

Hi All, I m a novice developer of Linux applications. Recently I faced a file system corruption. (I guess) I have a Kernel 2.4.7-10 with ext3 file system in compact flash. The system was up for 3 months and was running with average load conditions. One fine day, it just started sending kernel messages on the serial console. The message was like this. EXT3-fs error (device ide0(3,2)):

Hi, I'm having some serious problems diagnosing a hardware issue in my linux system. The following error occurs intermittently. I have replaced hard drives and it is still occurring. I'm trying to determine if it's a device conflict, a problem with the motherboard or something else. Can anyone help? hda: dma_intr: status=0x51 {DriveReady SeekComplete Error} hda: dma_intr: 0x40

Hi, yesterday my linux machine gave me some smartd errors so i checked the disk in another machine and it had defective sectors, I installed a new hard disk on the original machine. Today this is being reported in logwatch. I have a Maxtor (200gig) as hda, a cdrom as hdc and another hard disk that is used for storage as hdd. All plain IDE (not sata) --------------------- Kernel Begin

Hi, I have an ext3 file system question for a while: How to obtain failed file (inode) from LBA section reported by Linux kernel? The following lines are a simple example: ... FCbox1: Nov 1 04:08:59 FCbox1 kernel: hda: dma_intr: status=0x51 { DriveReady SeekComplete Error } FCbox1: Nov 1 04:08:59 FCbox1 kernel: hda: dma_intr: error=0x40 { UncorrectableError }, LBAsect=165843413, high=9,

One of my CentOS boxes has started giving me errors. The box is CentOS-4.4 (i386) fully updated. It has a pair of SATA drives in a software raid 1 configuration. The errors I see are: ata1: command 0xca timeout, stat 0x50 host_stat 0x24 ata1: status=0x50 { DriveReady SeekComplete } Info fld=0x1e22b8, Current sda: sense key No Sense ata2: command 0xca timeout, stat 0x50

I''ve been following unstable day to day with mercurial but I''m still having a problem with my HVM testing. I using the i686 Centos + Bluecurve isntaller and I get the following error in the guest during disk formatting: <4>hda: dma_timer_expiry: dma status == 0x21 <4>hda: DMA timeout error <4>hda: dma timeout error: status=0x58 { DriveReady SeekComplete

Help! I am running FC1, with a maxtor 160GB HD installed. Drive is only about a month old. I had just finished moving data from an older HD that was making some funny sounds and throwing some random errors. All was well. Last night we lost power for several hours and 1 machine's UPS/shutdown system didn't power down the workstation. The other 7 in our office did fine. The power

Is anyone else having major I/O peaks due to logrotate or other jobs running simultaneously across multiple guests. I have one KVM server running Centos 5.4 with local disk that is seriously suffering as most of the guests rotate their syslog at the same time. Looking at the KVM server I'm seeing 11:00:01 PM CPU %user %nice %system %iowait %steal %idle 03:40:01 AM

Hello LINUX GURUS, I am fairly new to LINUX OS, so pardon my ignorance about LINUX OS. I have installed LINUX 7.2 on IBM netfinity 4000R server. OS works fine for few days and start giving me this error message all of a sudden: "kernel: hda: dma_intr: status=0x51 { Driveready SeekComplete Error }" "kernel: hda: dma_intr: status=0x40 { UncorrectableError }, LBAsect=4944861,

Hello all, I am new to this list and hope that my mail is not OFF TOPIC. After looking around for 2 months now, to find a solution, I will try it here now. Now the scenario: I bought a new cool dell laptop: INSPIRON 8100, 512MB RAM, NVIDEA GeForce2Go 32MB, 30GB Hitachi hard disk and a DVD. I bought it with WinME preinstalled, because it wasn't possible to get it with linux nor without an

All, Trying to figure out how to deal with, I assume, a dying disk that's unfortunately on / (ext3). Getting errors similar to: Dec 31 20:44:30 mybox kernel: hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error } Dec 31 20:44:30 mybox kernel: hdb: dma_intr: error=0x40 { UncorrectableError }, LBAsect=163423, high=0, low=163423, sector=163360 Dec 31 20:44:30 mybox kernel: end_request:

Wondering if anyone here might better be able to diagnose an issue we're seeing, or point me to some guidelines for this sort of thing. There are two machines with identical hardware, both running Red Hat 7.3's stock SMP kernel (required due to third party software). Both have come down with the same symptoms after having run fine for a number of months. The initial errors were these: