similar to: New user needs help with configuration and setup

Time to kill some bad sample code people are copying from ;) This is a complete rewrite of the cirrus driver. The cirrus_mode_set() function is pretty much the only function which is carried over largely unmodified. Everything else is upside down. It is a single monster patch. But given that it does some pretty fundamental changes to the drivers workflow and also reduces the code size by

Time to kill some bad sample code people are copying from ;) This is a complete rewrite of the cirrus driver. The cirrus_mode_set() function is pretty much the only function which is carried over largely unmodified. Everything else is upside down. It is a single monster patch. But given that it does some pretty fundamental changes to the drivers workflow and also reduces the code size by

Hi all, First thing first: It works, I now no longer have a few dropped frames every 10s on my testbox here with the pageflip i-g-t tests. Random notes: - New design has per-crtc locks to protect the crtc input-side (pageflip, cursor) for r/w and the output state of the crtc (mode, dpms) as read-only. It also required completely revamped fb lifecycle management, those are now refcounted

Hello, I'm using Asterisk@Home. I'm still new to Asterisk, and trying to grasp it all. I'm wanting to do a simple setup of One SIP provider (Broadvoice) and 3 SIP Software Phones. I'm able to call the VoIP provided line fine and get dropped to the digital receptionist (or mailbox). However, when I try to send outbound calls I get "Error 503 Service Unavailable" and

I'm using Asterisk 1.0.4 with AMP and Broad Voice. I have that with only 5 XTen Lite phones. I'm able to call / etc with internal phones just fine. I can call outside Vonage Numbers, and other BroadVoice Numbers. I have vonage where I live (626) and can call that fine. However, other 626 numbers I get similar errors as below. However, everytime, I try to call cell phones, and or

I have a user that just got a broadband connection so she could have an extension off our pbx. The service is DSL and uses a speedstream 5200 dsl router. I sent her a Polycom IP300. At first it would not access the config files via ftp so I had tech support walk her through setting the phone's internal IP to be the dmz. This allowed me to set up the phone using the web interface and now

Hello list. I'm trying to rebuild the 2.6.9.67.0.20.EL kernel, but it fails even without modifications. How did I try it? Created a (non-root) build environment (not a mock ) Installed the kernel.scr.rpm and did a rpmbuild -ba --target=`uname -m` kernel-2.6.spec 2> prep-err.log | tee prep-out.log The build failed at the end: Processing files: kernel-xenU-devel-2.6.9-67.0.20.EL Checking