similar to: Use of VPNs

Hi All Could a VPN be used to help with SIP Tunneling and QoS issues. State 1: Two IP Networks Connected via the Public Internet transmitting VoIP Traffic Say a VoIP User and VoIP Termination Provider. Each side can put QoS onto their part, but if QoS does NOT exist between them then call quality will be bad anyhow. State 2: Same as above except a VPN tunnel is setup between each side. Thus

Hi All I'm trying to get my Ultra UPS connected. It connects using a standard USB cable I have --with-drivers=hidups in the configure command and I have lsusb showing Bus 001 Device 002: ID 0d9f:0001 Powercom Co., Ltd Bus 001 Device 001: ID 0000:0000 I have /dev/usb/hiddev0 now matter what I try I keep getting upsdrvctl start Network UPS Tools - UPS driver controller 2.0.3 Can't

I will shortly be replacing a couple of proprietary VPN boxes with a FreeBSD solution. Section 10.10 of the Handbook has a detailed description of how to do this. However I remember a lot of discussion about a year ago about whether the gif interface was necessary to set up VPNs like this or whether it was just a convenience, for "getting the routing right". A number of people said

Hi, Problem: I want 2 vpn tunnels for 2 subnets over one interface ipsec0. Documentation only describes config for 1 vpn or road warriors. I defined 2 vpn zones ''fre'' and ''swe''. #ZONE DISPLAY COMMENTS net Net Internet zone loc Local Local fre VPN_Fre VPN Fre swe VPN_Swe VPN Swe Interface ipsec0 is tunnel over eth1. Local is eth0. ipsec0 serves 2 zones: fre

Hi All Curious will this work Std. PSTN line ---x------ X100p | ------ Fax Machine Using a standard "home phone" pstn line with a splitter connecting a fax machine and X100 Asterisk Box Incoming Line: Can I have in the dial Plan [incoming] exten => s,1,Wait(1) exten => s,2,IfFax continue to ring, so that the Fax Machine gets it exten

I am looking at options for VPN connections from iPhones and iPod Touches to CentOS systems. We use OpenVPN for connections with Windows, Mac OS X, and other Linux systems, but there don't appear to be any OpenVPN clients for iPhones (presumably because there are no tun/tap interfaces available yet). My experiences getting IPsec running on CentOS systems with OpenVPN have not been pretty.

Hi All I'm trying to understand how I would send my fax ? If I use Word or what ever word processor or even an email client to create what I want faxed. I have *asterisk setup with and FXO Gateway that will make the call to the fax number I dial SIP extension 320 is the FXO gateway. How do I now get my email or word document to TIFF to then fax to the FXO gateway or SIP/320 ? I

Hi everyone. I have a problem with this command: @arp_table = `arp -n` When I execute it on console, all is perfect, but when I put it in the script on Rails the string arp_table is empty and I don''t view any result. If I do a script like that: @list = `ls -l` all works perfectly. Where is the mistake ? Thanks in advance -- Posted via http://www.ruby-forum.com/.

Hi, I use shorewall on 2 computers and I''m really happy with it. But now I came over a special case where my wisdom ends. I have 2 VPNs running via FreeS/WAN on the firewall host, and now I want to replace my hand made setup with shorewall. I use the same FreeS/WAN setup as it is working already. I read through the documentation but there are only examples of 1 static net2net VPN and 3

I use 3 Ubuntu server 14.04 as KVM guest. Now I run 5 tinc vpns in switch mode. I use the same key for every vpn. Every kvm has connect to the two other servers. I need 5 vpns to have 5 networks connected but seperated. 1 vpn was running fine, but now that I run 5 vpns, my kvm crashes sometimes. Especially when I stop tinc. I used tinc 1.0.26 from repo. Now I tried tinc 1.1 pre, same problem but

Has any advancement been made to get 3102 operational in either a SIP or H323 asterisk environment. A post back in time mentioned a downloader service. >From the posts and articles I have read, the NCP is acting like a bootp and tftp server which uploads the configuration to the phone?? Am I close? if so, where does one get the SIP image for he 3102 and 2102 phones? I had 8 donated, but they

I have clients, which connectin to Internet through vpn. I want to dynamically share bandwith between vpn connections, so if there few connections, then they get all bandwith, if more then they get their minimal guaranteed bandwith. my idea is: ip-up.local: tc class add dev $DEV parent 1:1 classid 1:2${1/ppp/} htb rate $[$RATEUP/$VPNS]kbit ceil ${RATEUP}kbps tc filter add dev $DEV protocol ip

On Sat, Mar 26, 2016 at 12:03:48AM +0100, albi at life.de wrote: > 1 vpn was running fine, but now that I run 5 vpns, my kvm crashes sometimes. Especially when I stop tinc. > I used tinc 1.0.26 from repo. > Now I tried tinc 1.1 pre, same problem but less often. > > Any help or idea why system crashes? So the KVM instance itself crashes? Or Linux inside the VM? Any error messages

Hi, I configured 2 vpn's between 2 servers. When starting the tinc on each server. De 2 vpns's look like 1 vpn. Can tinc be configure for multiple vpn's between 2 hosts or more. Lets say there are 3 servers A, B and C. I want a tinc vpn between host A en host B. And a second vpn between host B en C without is becoming one vpn. And for example a third vpn between host A en host

Hi All I have been looking around and haven not been able to find a working example I have a fresh/new install of Asterisk 1.6.2.0 with dahdi 2.2.1 and libpri 1.4.10.2 I use a sangoma A200 card so I am using wanpipe 3.4.7 If I use zaptel which I read I need for app_rxfax then asterisk crashes with segfaults on startup asterisk[2624]: segfault at 30353466 ip b7eb538b sp bffda26c error 4 in

hi all, http://www.newriders.com/books/title.cfm?isbn=1578702666 I searched the tinc archives and I know one of the authors asked a few questions about tinc. http://mail.nl.linux.org/tinc/2001-06/msg00030.html So...go out and buy it :) armijn -- --------------------------------------------------------------------------- armijn@nl.linux.org | http://people.nl.linux.org/~armijn/ | Penguin

Hi, I am thinking of purchasing a cheap Dlink VPN for testing purposes for use with my Asterisk box and would like to ask the list for advice on how to pick a VPN that will work with my box. I am a newbie to both VPN's and Asterisk so any advice will be appreciated. Thanks, Mike -------------- next part -------------- An HTML attachment was scrubbed... URL:

Hello, Researchers have shown that many operating systems, sometimes in default configurations, allow packets to be received on an interface with a destination address that does not match a route that would send return packets back out of that interface. For example, you have a LAN interface which uses the address range 192.168.1.0/24, and a WAN interface with a public IP address. In some

Hello, Researchers have shown that many operating systems, sometimes in default configurations, allow packets to be received on an interface with a destination address that does not match a route that would send return packets back out of that interface. For example, you have a LAN interface which uses the address range 192.168.1.0/24, and a WAN interface with a public IP address. In some

Hello, response time: how is it possible to increase the response time on Tinc VPNs. When I use tinc over a fast or giga-bit network connection the ping-response time is normally about 1800 to 2000 ms. Sometimes I get ping response times at about 2.500 to 3.000 ms over a normal Ethernet Connection or a television-cable connection within the same providers-network in the same city. The ping-time