similar to: Voicemail 0 for operator call routing

Good Afternoon R Help! On of my users is seriously thinking about moving to R from Splus. In his testing, he has already found some benefits to it. He has, however run into one issue, calling his Fortran functions in R. Previously, in Splus, he would do the following: 1. Compile via f90 the *.f program 2. link the object file to the Fortran IMSL libraries via the 'ld' command 3.

I want to set up RSYNC so it has root privilege on the remote server. I do not want to run rsync through inetd. I want to be able to limit who can use rsync when the remote end has root privilege. I prefer not to use rsync's internal user/secrets file. I do want to use SSH as the transport shell. With that in mind, here is what I tried. I wrapped the rsync single use daemon execution on the

Hello All, Has anyone had success building 64-bit R on Solaris 10 Sparc with the Oracle Studio Compiler suite? Could anyone start give me a clue. I have tried to no avail. Thanks, Nynese Nynese Tinsley, BSEE, MSCIS UNIX Systems Analyst Harvard School of Public Health Center for Biostatistics in AIDS Research 651 Huntington Ave, FXB 614 Boston, MA 02115 617-432-3244 office#

I am running rsync version 2.6.4 protocol version 29 on HPUX 11.11. The same version of rsync is being used on both the source and destination sides. I am running rsync across an SSH connection. The remote rsync process does not seem to be locating, or even attempting to locate an rsyncd.conf file, in either /etc/rsyncd.conf or the cwd/pwd of the rsync process. On the client side I am running

Hello all I am a researcher in the field of tourism and have just recently installed R64 and RStudio onto my Mac (running latest OS). I am ran into some problems installing additional packages. I have looked through the General FAQs and Mac FAQS but haven't been able to find a solution. I have downloaded the various packages I need from CRAN sources and while some have successfully installed

Hello R Help, I am attempting to install/build a 64-bit version of R to hopefully resolve some memory.limit problems for a user who is running a simulation. The 'configure' runs fine and the compilation (make) runs fine until the very last part (see below). I have libiconv in /usr/local/lib (no sure why I am getting the referencing error). The config.site file is attached. ANY HELP YOU

Has anyone seen a problem when booting into isolinux where the display will become scrambled looking almost like static on a TV. I am running a K8N Neo 2 motherboard with an AMD 64 3500+. I first thought something freaky was going on with my flat pannel so I swapped it out for a crt. That didn't fix the problem so I swapped out the geforce 4 card for a geforce 2 card with the same results.