similar to: IAX voice distortion with full upload channel /SIP ok

Hi, this is the scenario: One * is placed in a central location with more than enough up/down bandwidth. One * is placed behind a DSL 3000/384. Both * are linked via IAX trunking. Everything is fine until the upload channel of the remote site is filled with a download, then heavy voice distortion starts. Well of course this is expected. So I fooled around with HFSC QoS scheduling on the remote

I am having almost the exact same problem. I have the following setup: Debian Woody Kernel 2.4.18 CPU: P4 1.2GHz RAM: 1GB Asterisk - Latest CVS 1 TDM400P card Codec GSM I've been chasing down bandwidth issues, but have had no luck. We are still pursuing those issues. I just started configuring IAX, so I assumed it was related to my IAX configs. We just noticed this morning that SIP is

Hello all, We have the following problem: When calling via iax, the sound is off after a while - most often after about 5 minutes (sometimes later or earlier) - at one end or at both ends. While the channel is up, and packages are still being transmitted, you just can't hear anything. Sometimes you can hear something just a little, but with the voice greatly distorted, sounding like a

Hi All, At present calls over IAX2 (ilbc) are good but they suffer from occasional distortion. The strange thing is that the distortion can only be heard by the calling party and not the called party in 95% of cases. IAX2 is being used with trunking enabled, using the ztdummy module as a timing source. Bandwidth shouldn't be an issue as there is more than sufficient plus we use QoS

hi All, Our configuration is, ISDN PRI lines connected to Asterisk Server, SIP users connected to Asterisk We route calls from ISDN PRI to SIP users, We did a CVS upgrade few days ago, now the sip users(CISCO phones) are experiencing, distortion of voice while they are engaged in a call. ie, SIP users can here the call clearly, but the outside caller heres distorted voice. ie, to

I'm new to * and I have my * box connected to another * box located at my ISP via iax2. Using ilbc everyting works fine but with any other codec I've tried (gsm, ulaw, alaw) there is severe distortion on the sound going out of my box as well as a second or two of delay. The incoming sound quality is fine. This happens even if the outgoing sound is coming from the voice mail prompts on

Hi, is the following possible? I would like to transfer a call to my "personal" MeetMe conference room and get transferred there automatically as well. Currently I can transfer the call to the conference, have to hangup and then call the conference number myself. I would love to have this in one quick function. Moreover is there a way to disable the "You are currently the only

Hi all, is it possible to bridge a call between a Junghanns quadBRI card and a TDM400 in the same server? It should be I think, -- I am trying this and when an incoming call comes in, it hangs both up at the moment the bridge is attempted (and a subsequent 'qozap: dropped audio' error is show in the /var/log/messages) Any thoughts appreciated -- I've seen posts, but no clear

I will be on vacation from <22/06/06> to <30/06/06>. I will not be reachable on my mobile. I will have limited access to mails, and please expect a delayed response. In my absence, please contact the following: Ray Richard or Safeer Mohammed Thanks H.Gireesh

Hi We are currently using Asterisk 1.2.4 with IAX and app_meetme for conferencing, but are looking to move to SIP because of issues with an IAX control we're using. The reason we moved from SIP to IAX in the first place was because of the poor NAT traversal with SIP. At that stage we were using Asterisk 1.0.*. How does Asterisk 1.2.4 handle NAT traversal and firewalls compared to the older

Hello, I have been facing an issue that voice is getting distorted sometimes in MOH (MusicOnHold) application. I have checked and confirmed that lame is properly installed, even tried native formats (ulaw, alaw, gsm), but the randomly seen distortion in MOH can't be eliminated. I came to know about requirement of timing device for MOH and MeetMe and a very good illustration by Andrew

I am having major problems with the first run of Snom 360s that rolled out last month. I am working with the US vendor and they in turn are working with Snom but I wanted to see of anyone else was using these or having issues with them. Issues: Speakerphone/Hands Free volume spikes up and down during a call. You have to manually set the volume during every call. This makes it totally unusable.

Hey Everyone, I have been stumped by this all day. Basically, I have a data.frame of multiple columns. Of concern are "id" & "date" For some reason, oftentimes there are duplicates of data with the same date. I would like to remove the duplicates per different id (removing duplicate dates for the entire data.frame would leave nothing since different id's all have

Oftentimes I want to make outputs to be displayed on the R console. However, after I execute a program with a sink command in it the R console becomes unresponsive. Meaning that the following occurs in R console: > source("Program_containing_sink.R") > a<-1 > a > >sink() >a > R help says that sink() will bring output back to the console but i's not

I have multiple voiceage g729 licenses installed on a RH9 box, and have a remote C7960 configured to use it (low bandwidth). In calls like: Remote C7960 -> g729 -> asterisk -> g711 -> C7960 the audio is oftentimes rather choppy. Changing the remote 7960 to use g711 seems to eliminate/reduce the choppyness. Any ideas on what might be behind this?

Hi all, I routinesly rips my CDs to WAV and then convert to ogg vorbis format for use in my car and portable player. I don't usually notice anything amiss, but on the last track of Mike Oldfield's "Music of the Spheres" album ("Musica Universalis", at the very end crescendo), the converted .ogg file exhibits terrible distortion (sounds like digital clipping). This

Ok maybe it's just my imagination, but it looks like the one-line "duh" fix I committed from Andrej Vakrcka <ander@cauldron.sk> this week DRAMATICALLY reduces distortion in encoded files. Take a look and compair. --- >8 ---- List archives: http://www.xiph.org/archives/ Ogg project homepage: http://www.xiph.org/ogg/ To unsubscribe from this list, send a message to

I've been noticing lately what seems to be some distortian in the standard asterisk sound files, used for voicemail. These files are stored on the local Asterisk system. When Asterisk plays them, I can hear some cracles and pops. I'd never noticed these until recently. I did a little test. This sounds fine... exten => 1000,1,Answer exten => 1000,n,Wait,1 exten =>

Hi All, I've run into a small hiccup in encoding my audios with Speex. When I encode audience laughter and applause with 'speexenc' (version 1.0.1), the result is quite acceptable... until I enable VBR. Then it distorts horribly. My understanding of VBR is that it frees the encoder to vary the number of bits emitted to better maintain the quality requested, and so I would have

Hi listers! Have a problem with distortion in some analog lines. When some call comes in from PSTN the sound is really distorte, nothing can be understanded, but Internal calls work ok. Funny thing is that when I start/stop asterisk,dahdi, and wanrouter services eveything goes fine again. This is happening every week or so. I'm using asterisk 1.4.36, dahdi linux 2.2.0.2 and wanpipe 3.4.9