Displaying 7 results from an estimated 7 matches similar to: "ask problem about softphone--asterisk--softphone, Urgent!!!"
2003 Dec 13
2
voice mail - sip:notify message
Hi folks,
To provide MWI, * will send out a sip:notify message to the UA.
The originator of this message is asterisk, as shown below;
NOTIFY sip:1001@www.mysipproxy.com:5065 SIP/2.0
Via: SIP/2.0/UDP 66.121.xxx.yyy:5060;branch=z9hG4bK0466cb21
From: "asterisk" <sip:asterisk@66.121.xxx.yyy>;tag=as0ffb1bdc
<===============
To: <sip:1001@www.mysipproxy.com:5065>
Contact:
2009 Jan 25
2
asterisk help
hello! i'm new to asterisk.
i'm using CentOS 5.2 + ASterisk 1.6
when i finish installing asterisk, i configure sip.conf like:
[4455]
type=friend
username=4455
secret=1234
host=dynamic
context=internal
[4466]
type=friend
username=4466
secret=1234
host=dynamic
context=internal
and extensions.conf like:
[internal]
exten => 4455,1,Dial(SIP/4455)
2016 Apr 22
2
Dial command for SIP driver with To-header config
Hello,
I'm using the following Dial command syntax:
Dial*(SIP/peer/exten!sip:xyz at xyz.com <sip%3Axyz at xyz.com>*), the SIP URI
after the '!' mark should be set as To-URI in outgoing INVITE
from Asterisk.
It works, but problem is that To-URI formatting is a bit messed up,
It looks as follows:
*sip:sip:xyz at xyz.com <sip%3Asip%3Axyz at xyz.com>*, it seems that Asterisk
2004 Feb 08
1
Registering SJPhone with Asterisk
2015 Jul 16
2
How to create direct media with PJSIP.conf configurations in Asterisk 13?
Dear Asterisk-Users,
By means of Asterisk 11 and sip.conf, I got success implementing early media. That is, all information that come from callee (SIP 183 message/ SDP) is passed to the caller without any modification in the SDP body.
However, in Asterisk 13 and using pjsip.conf I'm still failing to do the same thing. See:
Softphojne1
2008 Jul 28
12
Segfault with GridCellChoiceEditor
I have a problem.
In my application I have a few Grid objects in a Notebook. The Grid objects
are populated via GridTableBase. Certain Grid cells need to have a choice
interface (I''m artificially enforcing foreign key constraints). All this
works to the point where you try to edit the value for that cell. The
choice box renders (i.e. the drop down arrow appears) then the application
2003 Aug 26
0
TDM10M && Siemens Euroset 2015
Hi all,
--------
I have installed a TDM400 with one active FXS port (TDM10B) an connected
it to a Siemens Euroset 2015 analogue phone.
I have installed some smom IP phones to the network as well and
configured them as usual (sip.conf). For configuring the TDM10B I have
used FXO signalling in /etc/zaptel.conf and in
/etc/asterisk/zapata.conf. I definded the TDM channel and the Snom
phones to the