search for: ztrtc

Displaying 5 results from an estimated 5 matches for "ztrtc".

2003 Nov 10
4
Asterisk timing
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Hi, As I understand it, IAX2 trunking requires zaptel timing. Zaptel timing is provided by Zaptel cards, ztdummy or ztrtc. ztdummy requires usb-uhci and ztrtc can't run on smp systems. So if you only have smp systems with ohci and no zaptel cards (because it's a sip/iax2 gateway) then you're screwed? - -- Regards, Tais M. Hansen ComX Networks Tel: +45-70257474 Fax: +45-70257374 -----BEGIN PGP SIGNATUR...
2003 Oct 15
5
newbie question: Meetme
Yes, I am a newbie too. I am having a problem with meetme. From what I have seen it will work without a Digium card but with audio problems. My goal is just to see how it works not the quality of the audio. When I dial into the conference room the following message is played: "That is not a valid conference number." On the console I get: "unable to open pseudo channel". As
2005 Jun 16
5
meetme - conf-invalid
Hi Peoples I am having problems with meetme, in that it responds with "conf-invalid" when I dial a conference number. I notice that there is a note with regards to ztdummy, and the need for that to be loaded. Is this still the case? Is meetme dependent on this module? I do NOT use zaptel cards in my system, and there for zaptel is not loading. Can anyone shed some light
2005 May 18
6
zaphfc troubles
...12.0 zaphfc: CCD/Billion/Asuscom 2BD0 configured at mem 0xc3840000 fifo 0xc2d58000(0x2d58000) IRQ 12 HZ 100 zaphfc: Card 0 configured for TE mode Registered Span 1 ('ZTHFC1') with 3 channels Span ('ZTHFC1') is new master zaphfc: 1 hfc-pci card(s) in this box. Registered Span 2 ('ZTRTC/1') with 0 channels Real Time Clock Driver v1.10e I'm using zaprtc as the gateway is running on a VIA motherboard without USB controller. When I'm doing ztcfg -vv: Zaptel Configuration ====================== SPAN 1: CCS/ AMI Build-out: 399-533 feet (DSX-1) Channel map: Channel 01:...
2005 Feb 17
4
can't enable trunking :(
I have successfully installed and configured the asterisk, the incoming and the outgoing calls are working fine, its a tremendous solution :) Now i want to enable trunking between two asterisk boxes, in the iax.conf i have put: [karachi] ... ... ... trunk=yes ... ... ... everything seems to work fine but when i load asterisk it says: -------------- Feb 17 10:59:14 WARNING[18726]: