Displaying 4 results from an estimated 4 matches for "wensveen".
2007 May 03
4
Re: Changes to megatec.c
...the UPS is likely to shut off before that, so I
guesstimated 11V for a 12V cell to be a reasonable "empty battery"
voltage.
- The float charge (clamping) voltage for a fully charged 36V battery
if 40.9V but I've subtracted 100mV to allow for tolerances
Kind regards,
Frank van Wensveen
---
* Origin: www.vanwensveen.nl (80.253.112.29)
2007 May 01
9
Trying to fix "Unsupported combination of battery voltage / nr. of batteries" error
...(voltage, other parameters reported by the UPS) cause
this error to occur?
- How can I get debugging info (e.g. the raw data reported by the UPS)
out of the driver or other portions of the code?
- Can I change set_battery_params() in megatec.c with impunity?
Thanks!
Kind regards,
Frank van Wensveen
---
* Origin: www.vanwensveen.nl (80.253.112.29)
2007 May 01
9
Trying to fix "Unsupported combination of battery voltage / nr. of batteries" error
...(voltage, other parameters reported by the UPS) cause
this error to occur?
- How can I get debugging info (e.g. the raw data reported by the UPS)
out of the driver or other portions of the code?
- Can I change set_battery_params() in megatec.c with impunity?
Thanks!
Kind regards,
Frank van Wensveen
---
* Origin: www.vanwensveen.nl (80.253.112.29)
2007 May 04
1
Any UPS hardware hackers ?
...width modulated by a driver signal coming from the
CPU and at least two chips with custom type numbers. Debugging the
processor system and PWM hardware is difficult because of the custom
chips on which I have no info at all.
Any response would be greatly appreciated!
Kind regards,
Frank van Wensveen
---
* Origin: www.vanwensveen.nl (80.253.112.29)