search for: videopost

I'm running a server with Centos 3 that I have set up a smbfs share to a Buffalo LinkStation. The LS has 4 drives configured with RAID 5. Each disk has 1 TB capacity, so the resulting drive is approximately 2.7 TB. When doing a df, the result shows 2 TB, and no used blocks. Is there some setting I can change so that Centos sees and uses all 2.7 TB or does Centos 3 not support this? Steve

Greetings. Sorry for the OT, but I'm looking for some advice regarding archiving. I've always been a tape archive believer, but with SATA drives becoming more reliable and much larger, I'm wondering if it is time to change my opinion. What are the benefits/pitfalls to begin archiving to "enterprise" level SATA drives? Is it possible to use Amanda or Bacula to archive

Greetings. I am planning on getting my RHCE in the near future. I thinking I should wait until 6 comes out before proceeding. That being said, I don't want to wait past the end of this year. That being said, do you all have any information about how long it takes for their training platform to catch up to their release? Which is to say, if RHES 6 is released on day 1, at what point

Greetings. I am attempting to install 5.1 x86_64, but it is dumping out during the post-install section. I was able to send a debug to a remote system. I've never looked through an install debug log before, but everything seems to be in order until after the "tar" install, at which point I get the following error: error: db4 error(-30977) from dbcursor->c_put:

Greetings. When I "pull" data from server A to server B, with nfs, server B reports a high load when viewed via uptime. The load is upwards of 6.x. Server A's load remains light. When I "push" the data, server A's and B's loads are relatively light. When I change the mount point from nfs to cifs, I don't see this problem. I also don't have this

Greetings. I am having issues with rpm/yum on a centos 5.2 x86_64. I am trying to update from 5.2 to 5.4. During yum update, the application became unresponsive during the package search. It had not begun to download any packages. I tried to do a "yum clean all", but that wouldn't complete either. I tried to do a rpm --rebuild, but that failed with a segmentation fault. Tried

Greetings. I am in the process of installing 5.1 64 bit on a server. The server has 2 3ware cards: 9550SX 12 port, and a 8006 2 port, both SATA. I want the 8006 board to be /dev/sda, and the 9550 to be /dev/sdb. My plan is to install the os on /dev/sda (8006), and data on /dev/sdb (9550). Unfortunately, the 9550 comes up as /dev/sda. The 8006 is installed in slot 3, which is a 100Mhz

Greetings. I am trying to create a 10TB (approx) ext3 filesystem. I am able to successfully create the partition using parted, but when I try to use mkfs.ext3, I get an error stating there is an 8TB limit for ext3 filesystems. I looked at the specs for 5 on the "upstream" vendor's website, and they indicate that there is a 16TB limit on ext3. Has anyone been able to create