search for: vadacom

...sage reports the correct amounts (let's say 1 new, 3 old) The phone will display new 1, and old 3 Then when the message becomes read (ie old), a new SIP notify message gets sent to the phone (0 new, 4 old), but the phone reports 0 new, and 0 old messages. -- Gerwin van de Steeg Engineer Vadacom Ltd W: www.vadacom.co.nz E: gerwin.van.de.steeg@vadacom.co.nz

I recently read about the following new technologies from Digium. Has anyone tried the new HPEC or knows when it will be available? TDM800P and HPEC The TDM800P is an 8-port analog telephony interface card, so it fills the gap between Digium's 4-port and 24-port cards. Analog phones and POTS lines are going to be with us for some time, and demand for support for them remains high. The

All, Using SIP with progressinband=yes I get Asterisk to generate the ringing sound for callers. However, I was wondering if it is possible to configure what is 'played back' to the calling party? i.e. instead of just 'ring ring' could I potentially play back a song from an MP3, WAV or GSM file? I'm thinking it would be quite cool to offer a customised 'ring'

Hello, Has anyone tried the combination of asterisk 1.2.24, zaptel 1.4.5 and HPEC 9.00.003? In particular, with a hardware configuration similar to: Module 0: Installed -- AUTO FXO (FCC mode) Module 1: Installed -- AUTO FXO (FCC mode) Module 2: Installed -- AUTO FXO (FCC mode) Module 3: Not installed Found a Wildcard TDM: Wildcard TDM400P REV I (3 modules) I have two fully independent systems

Hi people, I would like to read your suggestions as to where the issue might be. ATA286=Grandstream Budgetone ATA 286 in SIP mode. One Lan Port and one FXS port. TDM04B= 4 FXO signal fxls There is a 8FXO-to-SIP unit in this scenario that works perfectly so i will not make mention of it. PSTN----VOIPprovider---Internet---ATA286------tdm04b---Asterisk1.2.-13 Asterisk is being used as a meetme

Hello, I just installed a PRI and when I make a local (seven digit) call, I get Code 28 back from the telco, (I believe code 28 means "Invalid Number") and I hear a fast busy on the phone. Here is the output: -- Executing Dial("SIP/marke-17b1", "ZAP/G1/4967171") in new stack -- Requested transfer capability: 0x00 - SPEECH -- Called G1/4967171

I have about 20+ phones on a server, all set for registry expiry 1 min. But only this one, with 2 accounts, keeps re-registerting itself. All the time this is what I see on asterisk CLI and it is kind of annoying. What only this phone does this and no other. Its on a remote location. All phones are Grandstream GXP-2000. -- Registered SIP '502' at 64.101.221.250 port 18639 expires 60