search for: te411

Hi, How would one activate/deactivate hardware echo cancellation on the TE406 card? Can it be done per channel? I'm going to run TE406 in the following scenario: ISDN -> TE406 -> PABX I understand from Steve Underwood's site that echo cancellation is not good for faxes (and they do that themselves). So what I want to do and bypass echo cancellation for selected extensions before

Dear all, Does anyone try to install 2 or multiple TE411 card into one server? Can it be done? What about stability? Thanks Ray -------------- next part -------------- An HTML attachment was scrubbed... URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20060209/b65a1d46/attachment.htm

Has anyone on the list tried one of these new cards with built-in echo cancellation? This electronic message transmission, including attachments, is for the exclusive use of the individuals to which this e-mail is addressed and is to be reviewed and used exclusively for authorized company purposes. This transmission may contain proprietary, confidential or privileged information. If you are

Hello All, I'm looking to get some feedback on which solution of providing FXS is going to have the best results with faxing. I'm only looking to see what method is going to provide the best digitization into Asterisk, not for transmission from Asterisk to else where. Any recommendations of specific channel banks are welcome. I will need to provide approximatly 216 FXS Ports and need

Hi all, I replaced a TE410P Rev C 1st Generation Firmware with a TE411P without any cfg changes (zaptel/zapata). As a result Asterisk crashes on outbound from PRI4 going to PRI1 calls: Aug 23 18:22:00 WARNING[4693]: chan_zap.c:7545 zt_pri_error: PRI: !! Got a UA, but i'm in state 1 Aug 23 18:22:00 WARNING[4693]: chan_zap.c:7545 zt_pri_error: PRI: !! Got a UA,...

...so: >> Unnumbered frame: >> SAPI: 00 C/R: 0 EA: 0 >> TEI: 000 EA: 1 >> M3: 3 P/F: 1 M2: 3 11: 3 [ SABME (set asynchronous balanced mode extended) ] >> 0 bytes of data Sending Set Asynchronous Balanced Mode Extended This was true on both of our Te411 cards so I'd be surprised if both were defective. The cisco gateway that this Asterisk box is replacing is dms100, esf, b8zs so I just set the asterisk box with the same configuration. I spoke to the telco and they said everything looks good on their end, and since this a production T1 it...

Hello guys! I hope you bare with yet another newbie on the list! :-) I am trying to setup an asterisk installation in between a Siemens HiPath 3800 and my local carrier (Telefonica/Brazil). Both running R2. ISDN is not an option on the carrier. :-( I could apparently setup both E1s just fine according to zttool (both OK with no alarms) but, and this is where it starts to get