Displaying 3 results from an estimated 3 matches for "squid48".
2019 Jul 31
0
GPO issues - getting SYSVOL cleaned up again
...d only see hostname
> IP's as differences...
> > Virtual ips, firewalling, added winbind, nfs, strongswan,
> kerberos SSO auths.
> > Squid with 4 setups.. Pfew.. But guys, when done im posting
> this howto also.
> > With squid 4.8 on buster, ( hint : repo buster-squid48 ssl
> enabled )
> > What a dragon this was, strongswan is last what im on now.
> > If someone has a strongswan setup with user/ldap auth, pm
> me your config ;-)
> >
> >
> > Ok, what you posted below.
> >
> > pre01svdeb03 : apt-get remove --p...
2019 Jul 31
3
GPO issues - getting SYSVOL cleaned up again
...lived.
I'm almost done with this, you should only see hostname IP's as differences...
Virtual ips, firewalling, added winbind, nfs, strongswan, kerberos SSO auths.
Squid with 4 setups.. Pfew.. But guys, when done im posting this howto also.
With squid 4.8 on buster, ( hint : repo buster-squid48 ssl enabled )
What a dragon this was, strongswan is last what im on now.
If someone has a strongswan setup with user/ldap auth, pm me your config ;-)
Ok, what you posted below.
pre01svdeb03 : apt-get remove --purge --auroremove resolvconf
Old dc: pre01svdeb02 : apt-get remove --purge --aur...
2019 Aug 13
3
winbind - frequent high CPU utilization
Hi.
I use winbind + squid on Debian Buster to authenticate users + authorize
them based on groups they are in. It all works, well, good, but winbind's
CPU utilization peaks can reach up to 100%. The same solution ran OK on
Debian Jessie with up to 20% CPU utilization at most.
The configuration of Buster must have been updated based on the samba
version leap/shift compared to Jessie.
On