Displaying 5 results from an estimated 5 matches for "s508".
Did you mean:
508
2004 Sep 10
1
Sangoma S508 Rev-B
Hi list,
I've browsed through the wiki pages and finally would like to get some
answers from peple who perhaps had used such card. I have the sangoma
s508 card. It has no CSU/DSU. It is an ISA card with DB9 and DB25
connectors (for RS232 and V34/X21/EIA interfaces). They claim it is a
frame relay and syncronous ppp card.
Can I use this card with asterisk in any way but without subscription to
a Frame Relay account? Perhaps in similiar manner as T...
2005 Apr 30
8
Problem with Sangoma/Adtran 600 installation
...ces.
I ran through the wanpipe install instructions and configured it, now I can
run
[root@altpbx asterisk]# wanrouter hwprobe
-------------------------------
| Wanpipe Hardware Probe Info |
-------------------------------
1 . AFT-A101u : SLOT=1 : BUS=1 : IRQ=209 : CPU=A : PORT=PRI
Card Cnt: S508=0 S514X=0 S518=0 A101-2=1 A104=0 A300=0
So I know the card is there OK.
My /etc/zaptel.conf looks like:
span=1,1,0,esf,b8zs
loadzone = us
defaultzone=us
fxsls=1-12
I am only trying to get half to load for now to make it simple.
[root@altpbx asterisk]# ztcfg
Notice: Configuration file is /...
2006 Jun 02
1
sangoma cards in linux
Hi There,
we only have a /29 internet routable network from our ISP and a Cisco
1601 router with serial interface doing all the routing.
I was thinking of replacing that cisco with a linux box with a sangoma
card, also using quagga with ospf on for my internel networks
has anyone have expierence with this?
thanks
Sew
2006 Nov 16
1
Sangoma A101 gives 'no PRI configured on span 1' error
I upgraded from Tormenta2 to Sangoma A101. I followed the instructions, and
installation was successful. zttool, ztcfg, all show card is installed
properly. I copied the parameters from my old working zaptel.conf,
zapata.conf and zapata-auto.conf. Verified on Sangoma website that these
files are correct. Also configured wanpipe1.conf.
But doing all this didn't start the PRI channels. It says
2007 Jan 12
3
Linux as T1 router
Hello All,
I am thinking about using a linux server as a T1 router. I have searched
the list, but have not found a discussion about what I''m trying to do. I
have a situation where the Cisco router I''m using will not handle the
additional bandwidth I added recently. Unfortunately, I cannot afford the
Cisco unit that will. I would like to know if anyone has successfully done