search for: primary_reselect

...ed a correct VLAN, a we saw no problems when this machine was running Scientific Linux 6 (CentOS 6-like system). Any ideas? [root at dc106 ~]# cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) Bonding Mode: fault-tolerance (active-backup) Primary Slave: enp6s0 (primary_reselect always) Currently Active Slave: enp6s0 MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 600000 Down Delay (ms): 0 Slave Interface: enp6s0 MII Status: up Speed: 10000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 00:1b:21:91:aa:c5 Slave queue ID: 0 Slave Interface: enp7s0f...

...ordinary in your network files. I originally set up my bond using nmtui Here is my configuration: #Bond: BONDING_OPTS="ad_select=stable all_slaves_active=0 arp_all_targets=any downdelay=0 fail_over_mac=none lp_interval=1 miimon=100 min_links=0 mode=802.3ad num_grat_arp=1 num_unsol_na=1 primary_reselect=always resend_igmp=1 updelay=0 use_carrier=1 xmit_hash_policy=layer2" TYPE=Bond BONDING_MASTER=yes PROXY_METHOD=none BROWSER_ONLY=no BOOTPROTO=none IPADDR=a.b.c.249 PREFIX=24 GATEWAY=a.b.c.1 DNS1=a.b.d.253 DNS2=a.b.d.4 DNS3=a.b.d.12 DOMAIN=redacted.net DEFROUTE=yes IPV4_FAILURE_FATAL=no IPV6I...

...CAST ONBOOT=yes TYPE=Ethernet BONDING_OPTS="mode=1 arp_interval=500 arp_validate=1 arp_ip_target=GATEIP,GATE2IP primary=eth0" $ cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v3.6.0 (September 26, 2009) Bonding Mode: fault-tolerance (active-backup) Primary Slave: eth0 (primary_reselect always) Currently Active Slave: eth0 MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 ARP Polling Interval (ms): 500 ARP IP target/s (n.n.n.n form): GATEIP, GATE2IP Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 31 Permanent HW...

Hi! I just upgraded a machine to 7.7.1908 and the default route is not being set on boot. This particular server has a bonded interface, and the corresponding configuration for the master is ( /etc/sysconfig/network-scripts/ifcfg-bond0): TYPE=Bond BOOTPROTO=none DEFROUTE=yes IPV4_FAILURE_FATAL=yes NAME=bond0 DEVICE=bond0 ONBOOT=yes IPADDR=10.3.20.131 PREFIX=24

Hi all, Read many posts on the subject. Using 802.3ad. Few problems; Cannot ping some hosts on the network, they are all up. Cannot resolve via DNS which is one of the hosts that I cannot ping, internal nor external DNS hosts. Unplugging the NICS and plugging them back in will then not allow pining if the default d=gateway. When cold booting it somewhat works, some hosts are pingable while