search for: nc373i

...ow is HP hardware RAID-1's performance? Should I use HP's hardware RAID or software RAID in this case? Thanks a lot and looking forward to your answers. Chau My server configuration: HP DL380R05 E5420 2GB Base AP Server (1) Quad-Core IntelR XeonR Processor E5420 Two Embedded NC373i Multifunction Gigabit / 2 GB (2 x 1 GB) PC2-5300 Fully Buffered DIMMs (DDR2-667)/HP Smart Array P400/256MB Controller /Rack (2U)/Hot Plug Fully Redundant Fans Standard Two HP 146GB 10k 2.5 SAS HP SP HDD HP 1000W IEC C14 Cord RPS Kit -------------- next part -------------- An HTML attachme...

...pcib6: <ACPI PCI-PCI bridge> irq 40 at device 18.0 on pci0 pci11: <ACPI PCI bus> on pcib6 pcib7: <ACPI PCI-PCI bridge> irq 41 at device 19.0 on pci0 pci3: <ACPI PCI bus> on pcib7 pcib8: <PCI-PCI bridge> at device 0.0 on pci3 pci4: <PCI bus> on pcib8 bce0: <HP NC373i Multifunction Gigabit Server Adapter (B2)> mem 0xf8000000-0xf9ffffff irq 41 at device 0.0 on pci4 bce0: /usr/src/sys/dev/bce/if_bce.c(1258): Management firmware enabled but not running! miibus0: <MII bus> on bce0 brgphy0: <BCM5708C 1000BASE-T media interface> PHY 1 on miibus0 brgphy0...

I''ve just uploaded 0.9.11-pre7. save/restore should be working for 32 bits on both SMP and UP, and maybe for 64 bits although it''s not tested. If someone could test migration it would be much appreciated. The installer seems to not install the drivers under 64 bit environment... but they can then be installed manually. Not sure why at this point.

I''ve just uploaded 0.9.11-pre7. save/restore should be working for 32 bits on both SMP and UP, and maybe for 64 bits although it''s not tested. If someone could test migration it would be much appreciated. The installer seems to not install the drivers under 64 bit environment... but they can then be installed manually. Not sure why at this point.