search for: lachek

do you have selinux enabled? It should not be. p p.s. - if it comes to re-installing, you can backup all your settings with the freepbx backup utility and then restore so that you don't have to re-enter everything. From: "Lachek Butalek" <lachek@gmail.com> To: "Asterisk Users Mailing List - Non-Commercial Discussion" <asterisk-users@lists.digium.com> Date: Thu, 8 Jun 2006 12:24:24 -0400 Subject: [Asterisk-Users] FreePBX 2.1.0: Manually rewriting extensions_additional.conf Figuring I knew what...

Situation, simple home setup: * Trixbox 2.0 * Feature Codes installed * GNet PA-168V based ATA * Cheesy cordless analogue phone >From what I gather, dialing *70 from the handset should activate Call Waiting. All it seems to do is change the message "The person at <extension> is on the phone" to "<ring> <ring> The person at <extension> is

Figuring I knew what I was doing (I didn't - surprise) I added a totally unnecessary line in /etc/asterisk/extensions_additional.conf a couple of days ago. Troubleshooting a dialing rule issue, I'm now realizing that FreePBX is updating its database with the new settings but is not rewriting/updating extensions_additional.conf with the changes I'm making. I've tried renaming the

So I took a chance with an X100P knock-off on eBay. I'm running Asterisk + FreePBX on a PowerMac G3 (beige desktop) using Slackintosh 10.2 and kernel 2.6.16.16. Everything has been fine up until now. I compile the 1.2.5 Zaptel drivers without a problem, get the udev configuration in, modprobe zaptel, and finally modprobe wcfxo. At this point, I get the message: ZT_CHANCONFIG failed on channel

My mission is to get one * box to dial another * box' extensions. I have set this up previously without any issues by making a simple IAX trunk/extension pair on the two boxes and create a dial plan with a prefix like 9|XXX to select an extension on the other box. My problem is that I now have to do this with extremely restrictive firewalls thrown into the mix - firewalls I have no control

can someone overthere help? the server specs are as follows HP DL380G4 Dual Intel Xeon 3.2GHz processor with 4GB RAM, running fedora core 3 asterisk-1.2.5 ss7-0.8.3d. using sip as advised to receive calls from another gateway in US. using g729 in transcoding way. however, I noticed the call hit the 51 active calls which is 102channels, I run "top" to check the system resources usage

I've gotten nothing from http://bbs.atcom.cn on this so far. Perhaps someone on the list has experience with this. Is there a way to get MWI support for PA168V-based ATAs? Apparently some IP phones based on the PA168V chip has this support already (Atcom AT-320 for example) by configuring Asterisk with 'mailboxdetails=yes' in iax.conf. On my ATA, however, it does nothing. Any

Hi, guys. May be someone could give me advise? I am trying to find good VOIP provider ONLY for OUTGOING calls with low per channel cost and cheap rates on Eastern Europe, Turky and xUSSR. Should support g729 or g723 codecs, SIP or IAX connectivity. -- ========================================================================= = Best regards, Nikolay Pavlov.