search for: hfc_multi

Hi all, we're buildin an Asterisk box based on an Intel IXP425 board. The board uses a Beronet BN2S0 ISDN card, mISDN 1.1.4 and asterisk 1.4.2. hfc_multi has been patched to compile under big endian cpu, and so also capi kernel files. All the modules seem to load correctly (configuration was made with misdn-init config), but when starting cha_misdn, asterisk outputs the following lines: P[ 1] Restarting this port. P[ 1] Stack:0x174f10 P[ 1] empty_ch...

Hi, I get this error while compiling install-misdn on a Debian box with kernel 2.6.18: *make[2]: *** [/usr/src/install-misdn/mISDN/drivers/isdn/hardware/mISDN/hfc_multi.o] Error 1* *make[1]: *** [_module_/usr/src/install-misdn/mISDN/drivers/isdn/hardware/mISDN] Error 2* *make[1]: Leaving directory `/usr/src/linux-headers-2.6.18-2-486'* *make: *** [MISDN_MAKE_MODS] Error 2 *anybody knows why? TIA Giorgio

Dear all, I know this is more a Digium hardware than an Asterisk issue. Already posted a question at Digium, however also like to see whether anyone in the Asterisk community has encountered the following situation: I installed a Digium B410P BRI PCI card on my new asterisk server, following the steps specified in the manual. I can see the PCI card is available using the lspci command: ...

...9; card name: 'HFC-4S Digium Card' clock: normal ACPI: PCI Interrupt Link [LNEA] enabled at IRQ 19 GSI 20 sharing vector 0x62 and IRQ 20 ACPI: PCI Interrupt 0000:03:06.0[A] -> Link [LNEA] -> GSI 19 (level, low) -> IRQ 98 HFC-4S#1: defined at IOBASE 0xec00 IRQ 98 HZ 1000 leds-type 2 HFC_multi: resetting HFC with chip ID=0xc revision=1 Setting GPIOs calling vpm_init VPM: Chip 0: ver 33 VPM: A-law mode VPM reg 0x20 is 11 NLP Thresh is set to 2 (0x2) VPM: A-law mode VPM reg 0x20 is 11 NLP Thresh is set to 2 (0x2) rtc: lost some interrupts at 1024Hz. hfcpci_probe: DIPs(0x90) jumpers(0x0) 1...

...# Give the id of the PCM bus. All PCM busses with the > same ID > # are expected to be connected and have equal slots. > # Only one chip of the PCM bus must be master, the others slave. > # > # debug=<number> > # > # Enable debugging (see hfc_multi.h for debug options). > # > # dsp_options=<number> > # # set this to 2 and you'll have software bridging instead of > # hardware bridging. > # > # > # dtmftreshold=<milliseconds> > # > # Here you can tune the sensitivity of the dtmf tone...