Displaying 3 results from an estimated 3 matches for "gigabitethernet0".
Did you mean:
gigabitethernet1
2007 Apr 18
0
[Bridge] Re: [VLAN] newbie problems
...ite right about the routing, and i've advanced to the bridging
part.
But it will not work. I've finaly gotten access to the switch it's
connected to and from the logs i've got this output:
Jan 26 16:49:56: %SPANTREE-2-RECV_PVID_ERR: Received BPDU with
inconsistent peer vlan id 4 on GigabitEthernet0/1 VLAN40.
Jan 26 16:49:56: %SPANTREE-2-BLOCK_PVID_PEER: Blocking GigabitEthernet0/1
on VLAN0004. Inconsistent peer vlan.
Jan 26 16:49:56: %SPANTREE-2-BLOCK_PVID_LOCAL: Blocking GigabitEthernet0/1
on VLAN0040. Inconsistent local vlan.
As the logs show, it's getting blocked.
It happens when i ad...
2006 Jul 20
2
GRE over IPsec Cisco<-> Linux
...--------------------(ipsec endpoint)192.168.1.97
192.168.1.1(gre endpoint)-----------------(gre endpoint)192.168.1.97
192.168.2.110 gre tunnel 192.178.2.96/28 192.168.2.97
Here is the setup on te Cisco:
interface Tunnel6
ip address 192.168.2.110 255.255.255.240
tunnel source GigabitEthernet0/1
tunnel destination 192.168.1.97
exit
ip route 0.0.0.0 0.0.0.0 160.96.97.250
ip route 192.168.1.96 255.255.255.240 Tunnel6
ip route 192.168.1.97 255.255.255.255 GigabitEthernet0/0
! This last line is required to get around a recusive route error in the cisco
Linux setup:
IPSec.conf
rx1000test:...
2014 May 30
3
Centos box and Cisco 3750 VLAN's
Hello all,
I have a CentOS box that has a NIC (eth0) on which I defined 4 VLAN's
(counting the NIC itself): eth0, eth0.1, eth0.2 and eht0.3. Initially the
Cisco switch was not partitioned into VLAN's which means that the only VLAN
running on it was the default one (VLAN 1).
I have then played with VLAN's a bit on the switch and at this point have
two: VLAN 1 (which is default and can