search for: fubegra

I have two 500 GB drives on my system that are attached to built-in SATA ports on my Asus M4A785-M motherboard, running in AHCI mode. If I shut down the system, remove either drive, and then try to boot the system, it will fail to boot. If I disable the splash screen, I find that it will display the SunOS banner and the hostname, but it never gets as far as the "Reading ZFS config:"

Asterisk version: 1.2.0-beta1 -OR- CVS HEAD Hardware: Generic X100P clone connected to Panasonic KX-TA624-5 extension port The problem happens IF AND ONLY IF: - the Panasonic is set to use double rings - the X100P is set to answer immediately (I'm using DISA here) It does not happen consistently; sometimes Asterisk behaves normally. When the "strange state" happens, DISA usually

On my Asterisk installation, I've had to roll back to Zaptel 1.2.19. When I use 1.2.20, I get very bad echo problems. It seems to work OK if I use a quieter-than-normal speaking voice, but at a sufficient sound level, the echo "breaks through" and then never goes away. The problem goes away if I revert to 1.2.19. Hardware in question: Digium TE110P, Adtran TA750 channel bank,

The Panasonic KX-TA624 series PBXes (and similar models) support a DTMF integration feature that can be enabled for dedicated voice mail ports. What I want to do is connect an X100P FXO port to a jack on the Panasonic and make use of the Panasonic's DTMF call progress tones that it provides in DTMF integration mode. The integration works well when a Panasonic extension is forwarding into