search for: fdff0000

...CentOS 4 which (fortunately) is my test system. This card has been working flawlessly for the past few weeks. Today I did a cvs update to the latest head files, and the card is now not working. When I try a zaptel start, a series of messages appears on the console: Found TE410p at base address fdff0000, remapped to f8a34000 TE410P version c01a010b, burst ON, slip debug: OFF TE410P running with work queues. FALC version: 00000005, Board ID: 00 .. (a series of Reg Values) .. This driver does not support 1st gen modules and at the tty used to start the zaptel service: [root@foxtrot zaptel]# /etc/i...

...ant on this, but it smells fishy ! For completeness sake, driver was previously loaded ok: Zapata Telephony Interface Registered on major 196 Zaptel Version: 1.4.10 Zaptel Echo Canceller: MG2 ACPI: PCI Interrupt 0000:18:08.0[A] -> GSI 19 (level, low) -> IRQ 98 Found TE2XXP at base address fdff0000, remapped to f8854000 TE2XXP version c01a016a, burst ON Octasic optimized! FALC version: 00000005, Board ID: 00 Reg 0: 0x375a2400 Reg 1: 0x375a2000 Reg 2: 0xffffffff Reg 3: 0x00000000 Reg 4: 0x00003101 Reg 5: 0x00000000 Reg 6: 0xc01a016a Reg 7: 0x00001300 Reg 8: 0x00000000 Reg 9: 0x00ff2031 Reg 10:...

I''ve just uploaded 0.9.11-pre12 of the GPL PV drivers for Windows. Since -pre10 (and -pre11) I''ve fixed a heap of crashes that were plaguing xennet under load, and also rewritten the interrupt/event distribution logic to improve performance. Under windows 2003 I can now get network speeds of 1-2Gbit/second TX and 600Gbit/second RX, which is considerably better than I was

I''ve just uploaded 0.9.11-pre12 of the GPL PV drivers for Windows. Since -pre10 (and -pre11) I''ve fixed a heap of crashes that were plaguing xennet under load, and also rewritten the interrupt/event distribution logic to improve performance. Under windows 2003 I can now get network speeds of 1-2Gbit/second TX and 600Gbit/second RX, which is considerably better than I was

...goMIPS). NET: Registered protocol family 16 node 0 link 0: io port [1000, ffffff] TOM: 00000000e0000000 aka 3584M Fam 10h mmconf [e0000000, efffffff] node 0 link 0: mmio [fc000000, fdfeffff] node 0 link 0: mmio [e0000000, efffffff] ==> none node 0 link 0: mmio [a0000, bffff] node 0 link 0: mmio [fdff0000, ffffffff] TOM2: 0000000120000000 aka 4608M bus: [00, 07] on node 0 link 0 bus: 00 index 0 [io 0x0000-0xffff] bus: 00 index 1 [mem 0xf0000000-0xffffffff] bus: 00 index 2 [mem 0x000a0000-0x000bffff] bus: 00 index 3 [mem 0x120000000-0xfcffffffff] ACPI: bus type pci registered PCI: MMCONFIG for domai...