Displaying 4 results from an estimated 4 matches for "engil".
Did you mean:
engel
2018 May 12
2
Using NUT to signal an appliance
> I have a disk box from ACNC (Jetstor 416is) that has an UPS port. The manual describes an UPS port: “2. Uninterrupted Power Supply (UPS) Port (APC Smart UPS only) The subsystem may come with an optional UPS port allowing you to connect APC Smart UPS device. Connect the cable from the UPS device to the UPS port located at the rear of the subsystem. This will automatically allow the subsystem
2018 May 14
0
Using NUT to signal an appliance
Charles, thank you for the thoughtful and helpful reply!
The ACNC box uses an RS232 serial interface for UPS connection.
From: Charles Lepple [mailto:clepple at gmail.com]
Sent: Friday, May 11, 2018 6:47 PM
To: Koundakjian, Matthew @ Engility <Matthew.Koundakjian at Engility.com>
Cc: nut-upsuser at alioth-lists.debian.net
Subject: Re: Using NUT to signal an appliance
EXTERNAL EMAIL -- This message originates from outside of Engility.
I have a disk box from ACNC (Jetstor 416is) that has an UPS port. The manual describes an UP...
2014 Oct 09
3
configure: error: "Net-SNMP Libraries not found, required for SNMP drivers"
...p --with-wrap --with-snmp-libs="L/opt/csw/lib
l/libnetsnmp"
And get the following error:
configure: error: "Net-SNMP libraries not found, required for SNMP
drivers"
I'm pasting the whole output below along with the contents of my
/opt/csw/lib directory.
Brian Jester
Engility Corp.
619-553-5851
Brian.Jester at EngilityCorp.com
bjester at spawar.navy.mil
-bash-3.2# ./configure --with-snmp --with-wrap
--with-snmp-libs="L/opt/csw/lib l/libnetsnmp"
Network UPS Tools version 2.7.2
checking build system type... i386-pc-solaris2.10
checking host system type... i3...
2018 May 11
0
Using NUT to signal an appliance
Hi ....
I have a disk box from ACNC (Jetstor 416is) that has an UPS port. The manual describes an UPS port: "2. Uninterrupted Power Supply (UPS) Port (APC Smart UPS only) The subsystem may come with an optional UPS port allowing you to connect APC Smart UPS device. Connect the cable from the UPS device to the UPS port located at the rear of the subsystem. This will automatically allow the