search for: designassembly

Just spotted this on the VTun mailing list. Might be interesting, if there were a TUN/TAP driver for windows it would be a lot easier to make a M$ port of tinc. Not that I feel much motivation to do so... ----- Forwarded message from Michael Heyse <mh@designassembly.de> ----- From: "Michael Heyse" <mh@designassembly.de> To: "VTun mailing list" <vtun@office.satix.net> Date: Thu, 10 May 2001 14:39:41 +0200 Subject: [Vtun] Windows port Reply-To: vtun@office.satix.net Sender: vtun-admin@office.satix.net Hi everybody! Just skim...

Hi, there are two issues wich cost me some time to figure out and maybe it made sense if someone put them into the documentation and / or wiki, because without these addressed my system ran pretty instable and wasn''t very usable. This applies to xen-3.0 and kernel 2.6.12.6-xen: 1) Networking issue With the default bridged setup, networking was quite flaky, e.g. samba access from dom0

Has any one had any success with cow implementation in xen ? I found this somewhere http://www.atconsultancy.nl/cowloop/, has anyone tried it out with xen ? -- regards, Anand _______________________________________________ Xen-users mailing list Xen-users@lists.xensource.com http://lists.xensource.com/xen-users

Hello everyone. I am currently working on setting up new servers for my employer. Basically we want two servers, all of them running several VEs (virtual environments, OpenVZ) which can dynamically take over each others job if necessary. Some services will run concurrently on both servers like apache2 (load balancing), so those need concurrent access to specific data. We had a close look at