search for: b200p

I've just bought an OpenVOX B200p ISDN card - and if I remember correctly from last time I used one of these - it is possible to use either DAHDI or mISDN with it. Are there any factors to consider when choosing which software to use? Is one better than the other - or does one have features which are not present in the other?...

...pri with older versions of Asterisk, but now I would like to upgrade to Asterisk 1.6. Question, should I be using mISDN or libpri for these cards when they are in the same system, or does DAHDI now support both cards under asterisk 1.6 reliably? I'm especially concerned about the OpenVox B200P as I haven't used it before. Thanks

Hello- I have a system with one D410P and one B200P (both OpenVox). All is well with the D410P, inbound and outbound, and I can initiate calls on the B200P BRI span, but there may be something wrong with my inbound BRI setup: there is no indication of an inbound call when I dial in to it from the PSTN. When I run "pri intense debug&quot...

Hello I have just set up Asterisk Asterisk 1.4.21.2 on a CentOS 5.2 machine. I am using the OpenVox B200P ISDN card. My problem is that even though chan_misdn module seems to be loaded correctly with Asterisk (I can see it using 'module show' command) the misdn commands are not available to me in the CLI so I cannot tell if my box is correctly interfacing with the ISDN card Any ideas what can...

Good Evening, The company I work for is attempting to connect an Cisco ISDN Router to an OpenVOX B200P BRI Card so that we can get it to dial out across an existing ISDN PRI Line also installed in the Asterisk PBX Everything has compiled successfully and the BRI card has been detected when mISDN is started: # misdnportinfo Port 1: NT-mode BRI S/T interface port (for phones) -> Interface can b...

Hello- After configuring DAHDI and starting asterisk, I get the following message continuously on the Asterisk console: WARNING[2057]: chan_dahdi.c:4158 pri_find_dchan: No D-channels available! Using Primary channel 16 as D-channel anyway! My card is a D410P configured for E1, only the first span is configured, and configuration snippets are as follows: From /etc/dahdi/system.conf:

Hello all What I'm looking for is some plain speaking advice on ISDN. Currently using 4 analog lines connecting via a four port TDM400P FXO card. We need to physically move our installations, and on requesting the analog lines be moved - our telco (BT) is suggesting we replace our analog lines with ISDN2. We would have 3 x ISDN2 connections, giving us six voice channels. They've