search for: actuely

2 years ago at one Meetup in Paris, Marc Girondot, professor at University Paris-Saclay, presented his cluster built with 12 Odroid (equivalent to Rapsberry Pi). The stack was almost the same size than your picture as there was no fan and a narrower distance between each PCB card. There were many more cables. For a total cost of less than 1000 ? and an electrical consumption reduced by a

...t recognize the dialed extension... Here is what I get: Phone 1 (working one): I press 11 and take it of hook: == Primary D-Channel on span 1 up for TEI 64 -- Extension '11' in context 'from-zap' from '0010618115711' does not exist. This is fine. I dialed 11 and it actuely does not exist. Phone 2 (the one which is unable to dial) I press 11 and then take it off-hook: == Primary D-Channel on span 1 up for TEI 64 -- Accepting voice call from '010618115711' to 's' on channel 0/2, span 1 -- Executing NoOp("Zap/2-1", "BLAH s"...

First of all, hello to the list. I'm currently migrating from a /etc/passwd and /etc/shadow based configuration to a MySQL based one using dovecot 99.14 on debian sarge. The problem is that the /etc/shadow containes both DES encoded (Crypt) and md5 based passwords. I've set the default system to be Crypt, and have added {MD5-CRYPT} in front of the md5 passwords in place of the $1$

Hello everybody, I hope somebody can tell me what is going wrong and how it can be fixed. To be honest: I have walked through the test document, and smbd and nmbd seem to work quite properly. However this is the case: Recently one of our smb-servers was suffering from a very bad HD. So I took another and installed linux on it (Slackware 8.1) and took most of the config files (among which

Using DIAX softphone which seems to be working OK can get to VM/echotest etc in the demo context Am trying to setup FWD but get the following problems Can hear it ringing when dialing FWD no 612 for time. Connects but no sound from remote end. Does anyone have any suggestions. Softphone on 192.168.0.2 asterisk on 192.168.0.3 Netgear RP114 doing NAT to the internet port 5060 being forwarded to

I've finally managed to run Dovecot without errors in two computers with maildir and indexes stored in NFS. I added a page to wiki about this: http://wiki.dovecot.org/NFS Suggestions how to keep attribute cache enabled but to allow Dovecot to specifically request not to use a cached value (when it's important) would be welcome. -------------- next part -------------- A non-text