search for: 80w

I have a TDM400p with 3 fxs and 1 fxo daughter cards. It's in a mini-itx case with a 'right-angle' PCI riser card so the TDM400p is 'sandwiched' between the Atom D525 CPU and the 2.5" hard drive. I'm getting a bunch of clicks and pops on all ports. Has anybody had a similar experience? Did you find a solution? -- Thanks in advance,

Hi, I've recently bought the UPS in subject to support a small load (around 60-80W). I've installed nut and did the basic configuration and confirmed basic communication. At that stage I did not configure upsmon, but simply was monitoring the values. I carried out a test to see how long the setup would last - according to the values reported via upsc - it should have been aro...

Slightly OT, but I think this is of possible interest to many of you, I need to get a UPS for my asterisk box. They are rated in VA but I can't quite figure out how that converts to real life. I have a PIII-800 box with two X100P and one TDM400P plus graphics adapter, an IDE hard drive etc. Will a small 400VA box be enough for this? tia

...End Sector FIFO flush: no no Prefetch Buffer: no no Post Write Buffer: no no Enabled: yes yes Simplex only: no no Cable Type: 80w 40w -------------------drive0----drive1----drive2----drive3----- Transfer Mode: UDMA PIO PIO PIO Address Setup: 30ns 120ns 30ns 120ns Cmd Active: 90ns 90ns 90ns 90ns Cmd Recovery: 30ns 30ns 30ns...