How would I test in debugging mode my acl config?
I have the greylisting package installed and it works fine except that
adding an ip to /etc/greylistd/whitelist-hosts doesn''t seem to do any
good.
The php-general mailing list adds a message id to the From address so
greylistd thinks that every message is from someone new.
I also have a case where the sender tries twice only within about two
minutes and then gives up.
I''d like to whitelist both of these domains/ips but nothing
I''ve tried
helps. (Yes, both daemons have been restarted.)
--
"There is only one way... to get anybody to do anything. And that is by
making the other person want to do it." -- Dale Carnegie
Rick Pasotto rick at niof.net http://www.niof.net
Hallo Rick, On Sun, May 11, 2008 at 06:15:43PM -0400, Rick Pasotto wrote:> How would I test in debugging mode my acl config? >Install ''swaks'' and look at the example in the documentation where it use the --pipe option with exim at the localhost and the -bh switch. Otherwise you can just use exim -bh (check the documentation on how to use it) on the commandline. Swaks just make it easier. Regards Johann -- Johann Spies Telefoon: 021-808 4036 Informasietegnologie, Universiteit van Stellenbosch "Study to shew thyself approved unto God, a workman that needeth not to be ashamed, rightly dividing the word of truth." II Timothy 2:15