Ocfs2 users - Nov 2006 - Unable to load module "configfs"

I've seen others with a similar problem, but have yet to find a solution.
I'm using CentOS 4.4, installed the ocfs2 package to match my kernel.
Installed ocfs2tools. I can open the ocfs2console just fine, but when trying
to add a node, it tells me the cluster stack could not be loaded. When I do
/etc/init.d/o2cb configure, I get:

Cluster to start on boot (Enter "none" to clear) [outreachData]:
Specify heartbeat dead threshold (>=7) [10]:
Writing O2CB configuration: OK
Loading module "configfs": Unable to load module "configfs"
Failed

If I do "locate configfs", I get:
/lib/modules/2.6.9-42.0.3.ELsmp/kernel/fs/configfs
/lib/modules/2.6.9-42.0.3.ELsmp/kernel/fs/configfs/configfs.ko

I tried disabling SELinux, as that seems to break many things until you get
the policy right. Same problem though. Anyone have any thoughts?

Thanks,

Rob

For the sake of the list and anyone that may run into this, sure enough
depmod fixed it. Should have been one of the first things I checked...

Thanks,

Rob
> 
>> Loading module "configfs": Unable to load module
"configfs"
>> Failed
>> 
>> If I do "locate configfs", I get:
>> /lib/modules/2.6.9-42.0.3.ELsmp/kernel/fs/configfs
>> /lib/modules/2.6.9-42.0.3.ELsmp/kernel/fs/configfs/configfs.ko
>> 
>>   
> Haven't had this problem myself (OCFS2 is statically compiled in my
> custom kernel), so I'm only guessing here, but does the output of
'uname
> -r' match the kernel version of the module (2.6.9-42.0.3.ELsmp)? If not
> then you should install the modules for the right kernel version. If it
> does match, then try 'modprobe configfs' and see what the output
is...
> If it says it can't find the kernel module, you might have to run
> 'depmod -e' and try again.