Bob Blackwell
2009-Nov-11 16:12 UTC
[Nut-upsuser] Input Voltage Not Shown - RS900 - Web Interface
I've just upgraded from r1865 to r2103. After doing so Input voltage for an APC RS900 no longer appears on the web tools graph. Instead of seeing a bar indicating Input Voltage the words "Not Supported" appears. Why does the graph no longer report Input Voltage when selecting "All Data" does; Back-UPS RS 900 battery.charge : 47 battery.charge.low : 10 battery.charge.warning : 50 battery.date : 2001/09/25 battery.mfr.date : 2008/06/05 battery.runtime : 1331 battery.runtime.low : 120 battery.temperature : 29.2 battery.type : PbAc battery.voltage : 23.8 battery.voltage.nominal : 24.0 device.mfr : American Power Conversion device.model : Back-UPS RS 900 device.serial : 5B0743U08220 device.type : ups driver.name : usbhid-ups driver.parameter.pollfreq : 30 driver.parameter.pollinterval : 2 driver.parameter.port : AUTO driver.version : 2.5_r2103 driver.version.data : APC HID 0.95 driver.version.internal : 0.34 input.sensitivity : medium input.voltage.nominal : 120 output.voltage : 120.0 output.voltage.nominal : 120.0 ups.beeper.status : muted ups.delay.shutdown : 20 ups.firmware : 9.o2 .D ups.firmware.aux : o2 ups.load : 16.0 ups.mfr : American Power Conversion ups.mfr.date : 2007/10/24 ups.model : Back-UPS RS 900 ups.productid : 0002 ups.serial : 5B0743U08220 ups.status : OL DISCHRG ups.test.result : In progress ups.timer.reboot : 0 ups.timer.shutdown : -1 ups.vendorid : 051d
Arjen de Korte
2009-Nov-11 16:33 UTC
[Nut-upsuser] Input Voltage Not Shown - RS900 - Web Interface
Citeren Bob Blackwell <rc.blackwell op yahoo.ca>:> I've just upgraded from r1865 to r2103. After doing so Input voltage > for an APC RS900 no longer appears on the web tools graph. Instead > of seeing a bar indicating Input Voltage the words "Not Supported" > appears. Why does the graph no longer report Input Voltage when > selecting "All Data" does;[...]> input.voltage.nominal : 120Could you run the *driver* in debug mode and post the first 20 seconds worth of output here? /path/to/usbhid-ups -DDD -a <upsname> This could be due to a recent change in reading reports. The only way to tell if this is the case, is by looking at the debug output. Best regards, Arjen -- Please keep list traffic on the list