Hello, I'm trying to setup my UPS using the "megatec" driver, but for now without success. from what I understood, the UPS should be connected to serial port (despite being an USB UPS), so I did i. sudo upsdrvctl start Network UPS Tools - UPS driver controller 2.0.5 Network UPS Tools - Megatec protocol driver 1.5 (2.0.5) Carlos Rodrigues (c) 2003-2006 Megatec protocol UPS not detected. Driver failed to start (exit status=1) ----- sudo /lib/nut/megatec -DD -a mustek Network UPS Tools - Megatec protocol driver 1.5 (2.0.5) Carlos Rodrigues (c) 2003-2006 debug level is '2' Starting UPS detection process... Attempting to detect the UPS... Sending "Q1" command... Wrong answer to "Q1" command. Attempting to detect the UPS... Sending "Q1" command... Wrong answer to "Q1" command. Attempting to detect the UPS... Sending "Q1" command... Wrong answer to "Q1" command. Attempting to detect the UPS... Sending "Q1" command... Wrong answer to "Q1" command. Attempting to detect the UPS... Sending "Q1" command... Wrong answer to "Q1" command. 5 out of 5 detection attempts failed (minimum failures: 2). Megatec protocol UPS not detected. ---- Any help would be appreciated. Igal. -------------- next part -------------- An HTML attachment was scrubbed... URL: http://lists.alioth.debian.org/pipermail/nut-upsuser/attachments/20071215/b84a4af3/attachment.htm
On Dec 15, 2007 6:47 PM, Igal <igalfr at gmail.com> wrote:> Hello, > I'm trying to setup my UPS using the "megatec" driver, but for now without > success. from what I understood, the UPS should be connected to serial port > (despite being an USB UPS), so I did i.What do you mean "despite being an USB UPS"? That model should work when using its serial port connection. Can you provide more info? (The configuration you are using, for example.) -- Carlos Rodrigues