Hi, Has anyone had problems with version 1.4.6* working with QLogic drivers (qla23xx)? We are seeing issues where the boot process hangs just after the HBA is recognized. In fact, the kernel never gets to initializing the second HBA because it is stuck on the first card. We''ve tried building from source and that doesn''t seem to fix the problem. Below is a section of the startup output: -- Jordan Schweller Systems Developer/Engineer * (E): jordan@osc.edu * (V): 937.328.5708 * (F): 937.322.7869 -------being kernel output------ Red Hat nash version 4.2.1.6 starting Mounted /proc filesystem Mounting sysfs Creating /dev Starting udev Loading scsi_mod.ko module SCSI subsystem initialized Loading sd_mod.ko module Loading ips.ko mACPI: PCI interrupt 0000:08:0e.0[A] -> GSI 38 (level, low) -> IRQ 217 odule scsi0 : IBM PCI ServeRAID 7.10.18 Build 731 Vendor: IBM Model: SERVERAID Rev: 1.00 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sda: 71096320 512-byte hdwr sectors (36401 MB) SCSI device sda: drive cache: write through SCSI device sda: 71096320 512-byte hdwr sectors (36401 MB) SCSI device sda: drive cache: write through sda: sda1 sda2 sda3 sda4 < sda5 sda6 > Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 Vendor: IBM Model: SERVERAID Rev: 1.00 Type: Processor ANSI SCSI revision: 02 Vendor: IBM Model: 25R5170a S320 0 Rev: 1 Type: Processor ANSI SCSI revision: 02 Loading scsi_transport_fc.ko module Loading qlaQLogic Fibre Channel HBA Driver 2xxx.ko module ACPI: PCI interrupt 0000:03:03.0[A] -> GSI 72 (level, low) -> IRQ 201 Loading qla2300.qla2300 0000:03:03.0: Found an ISP2312, irq 201, iobase 0xffffff0000018000 ko module qla2300 0000:03:03.0: Configuring PCI space... qla2300 0000:03:03.0: Configure NVRAM parameters... qla2300 0000:03:03.0: Verifying loaded RISC code... qla2300 0000:03:03.0: LIP reset occured (f7f7). qla2300 0000:03:03.0: Waiting for LIP to complete... qla2300 0000:03:03.0: LOOP UP detected (2 Gbps). qla2300 0000:03:03.0: Topology - (F_Port), Host Loop address 0xffff scsi1 : qla2xxx qla2300 0000:03:03.0: QLogic Fibre Channel HBA Driver: 8.01.02-d4 QLogic QLA2340 - 133MHz PCI-X to 2Gb FC, Single Channel ISP2312: PCI-X (133 MHz) @ 0000:03:03.0 hdma+, host#=1, fw=3.03.18 IPX -------end kernel output-------- -------------- next part -------------- A non-text attachment was scrubbed... Name: not available Type: application/pgp-signature Size: 191 bytes Desc: This is a digitally signed message part Url : http://mail.clusterfs.com/pipermail/lustre-discuss/attachments/20060403/a6845126/attachment.bin