Howdy, I have searched and read many other mailing list posts/usenet posts etc, however seem unable to find a direct answer for my problem.... I have a 2Mbit link network, and was wanting to limit 20 ip addresses, in the range x.x.x.20 to x.x.x.40 to downloading at 40Kb/sec. I setup cbq with cbqinit on there, and tried having 2 class files, one for external and internal interface, and limiting the rate to 400Kbit and the weight to 40, and having a RULE=IP for each ip address...., however the machines seem to be sharing bandwidth, eg if to start downloading they get roughly 25 between them. I am unable to modify any iptables rules, why that is so is not relevant, however I simply do not have the ability to play with marking, and need an alternative such as rshaper/cbq/wondershaper I am currently trying to get rshaper working, and am wondering if that will work out to be a better solution...eg will it work as I am expecting if I use rshaperctl to add a rule for each ip? Otherwise, what other tools/suggestions could be advised? Many thanks in advance, Josh _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
try pyshaper - http://www.freenet.org.nz/python/pyshaper Very easy yet very versatile Josh Beagley wrote:> Howdy, > > > I have searched and read many other mailing list posts/usenet > posts etc, however seem unable to find a direct answer for my > problem.... > > I have a 2Mbit link network, and was wanting to limit 20 ip > addresses, in the range x.x.x.20 to x.x.x.40 to downloading > at 40Kb/sec. > > I setup cbq with cbqinit on there, and tried having 2 class > files, one for external and internal interface, and limiting > the rate to 400Kbit and the weight to 40, and having a > RULE=IP for each ip address...., however the machines seem to > be sharing bandwidth, eg if to start downloading they get > roughly 25 between them. > > I am unable to modify any iptables rules, why that is so is > not relevant, however I simply do not have the ability to > play with marking, and need an alternative such as > rshaper/cbq/wondershaper > > I am currently trying to get rshaper working, and am > wondering if that will work out to be a better solution...eg > will it work as I am expecting if I use rshaperctl to add a > rule for each ip? > > Otherwise, what other tools/suggestions could be advised? > > Many thanks in advance, > Josh > _______________________________________________ > LARTC mailing list / LARTC@mailman.ds9a.nl > http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/ >-- Kind regards David -- leave this line intact so your email gets through my junk mail filter _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/