On Wednesday 12 December 2001 00:38, you wrote:> Hello,
>
> On Tue, 11 Dec 2001, Arne Hueggenberg wrote:
> > Hi,
> >
> > i have a problem with my setup.
> > The box has 3 interfaces
> > to the cable modem,
> > to the dsl modem
> > to the switch serving our other boxes
> >
> > all boxes on the switch have static ips
> > behind the cable modem is a subnet with hosts with static ips on the
sae
> > subnet
> > in behind the cable modem is also the default
> >
> > the arp-proxying is done between the cable interface and the switch
> > interface
> >
> > the third goes to the adsl modem
> > we do masqing on this interface
> >
> > now, some of the boxes on the switch are supposed to go out over the
adsl
> > line, and some are supposed to go via the gateway behind the cable
modem.
> > default route via the adsl, and a seperate table for those supposed to
go
> > via the cable.
> >
> > Now, when we add that table everything works as its supposed to.
> > But if a windows box reboots it suddenly complains the switch
interface
> > had its ip and doesent configure the interface
> > if we remove the table it boots fine
> >
> > Anyone have an idea what might be the problem?
>
> It seems the proxy ARP feature is activated for wrong route.
> See the following URL and try to differentiate your devices by the
> medium they are attached to. Then your router will know that the
> target host can see the broadcast probes and will not reply for them.
> For this to work, you need correct routes. The problem can be that
> the proxy_arp feature does not know that two devices are attached
> to same medium and the ARP reply should not be generated.
>
> http://www.linuxvirtualserver.org/~julian/#medium_id
>
> As I can''t fully understand your settings, if you have some
questions,
> please provide some settings. And of course, the main thing: how
> many distinct mediums you have. Read medium_id.txt for more
> information.
{public subnet with gateway} -- --[cable modem]
|
|
[box 1 with ip on public subnet] |
\ / |
\ proxy-arp |
\ / |
[switch]-- - - - -linux router}
/ |
/ |
[box 2 with ip on public subnet] |
|
|
[adsl-modem]
|
|
|
ISP
So the linux router has 3 ethernet cards
proxy arp is needed between the switch and the cable modem
reason being that the cable modems use Time Division Multiplexing, and with
everyone her using his own cable modem performance goes against 0
unfortunalty the cable modems only work with a single mac adress on the other
end, so we have to do proxy arp
now, box 1 is supposed to be routed via the gateway behind the dsl line, and
box 2 is supposed to be routed via the gateway on the subnet behind the cable
modem.
Wich works fine if i add the necessary rules, except for the fact that if box
1 wich runs windows is rebooted it complains about the linux router stealing
its ip adress
so the linux router has host routes for box1 and box2, a network route for
the public subnet and a default route over the DSL, with an table for box
specifying the gateway behind the cable modem as default route
only that when the tables up we run into problems with the proxy-arp
cant access the box right now so i cant post configuration yet, but will as
soon as its back up
> Regards
>
>--
>Julian Anastasov <ja@ssi.bg>
--
Arne ''zal'' Hueggenberg <zalaster@nef.wh.uni-dortmund.de>