Hi, I've recently installed a new sata-controller on a fresh installed FreeBSD 6.2. I gave the manual ata(4) a quick look before I bought the controller and it tells me this chip should be supported. But the machine panics every few minutes when I have a disk connected to it. Is there a way to fix this? heh. kernel: atapci0: <SiI 3512 SATA150 controller> port 0xdff0-0xdff7,0xdfe4-0xdfe7,0xdfa8-0xdfaf,0xdfe0-0xdfe3,0xdf90-0xdf9f mem 0xfe5ffc00-0xfe5ffdff irq 22 at device 11.0 on pci1 kernel: ad6: TIMEOUT - WRITE_DMA retrying (1 retry left) LBA=244892063 fee kernel: fee kernel: kernel: Fatal trap 12: page fault while in kernel mode kernel: fault virtual address = 0x28 kernel: fault code = supervisor read, page not present kernel: instruction pointer = 0x20:0xc0685de4 kernel: stack pointer = 0x28:0xcbeeac28 kernel: frame pointer = 0x28:0xcbeeac30 kernel: code segment = base 0x0, limit 0xfffff, type 0x1b kernel: = DPL 0, pres 1, def32 1, gran 1 kernel: processor eflags = interrupt enabled, resume, IOPL = 0 kernel: current process = 6 (thread taskq) kernel: trap number = 12 kernel: panic: page fault kernel: Uptime: 33m38s kernel: Cannot dump. No dump device defined. kernel: Automatic reboot in 15 seconds - press a key on the console to abort kernel: Rebooting...