My fileserver is running on a M6000 (pre-CL10000) using FreeBSD 5.2
I had some troubles compiling the kernel. The trick was to use :
- i686 in the kernel config
- i586 in the make file (full 686 compilation cannot be used due to a
missing instruction)
But in your case I think you processor supports 686 for the compilation.
You shouldn't have a problem with 4.9 due to the older gcc (less
options) as far as compilation goes. Now you should check if the network
interface is supported.
I forgot, are you planning to run X on it ? I didn't hear a lot of good
thing regarding XFree86 support on the CLE266.
Hope this will help.
Dany
Christophe Prevotaux wrote:
>Hello,
>
>I would like to know if FreeBSD 4-STABLE (or 4.9 Release) supports
>the Via Epia CL10000 Motherboard and CPU VIA C3 1Ghz ?
>
>_______________________________________________
>freebsd-stable@freebsd.org mailing list
>http://lists.freebsd.org/mailman/listinfo/freebsd-stable
>To unsubscribe, send any mail to
"freebsd-stable-unsubscribe@freebsd.org"
>
>