freebsd stable - Jan 2004 - sis driver

Hello,

I want to change my SMC network card using de driver by a Netgear FA311
card using sis driver.
I have also a Rhine III (vr) interface on the same computer.

The 'de' works fine.
When I install the sis I can send ping but never obtain the reply!
ifconfig reports a coorect configuration with ipaddress (static in
rc.conf)
When I ping I can see the led blinking on the otherside.
I tried few configurations without success. 

de0: <Digital 21041 Ethernet> port 0xb000-0xb07f mem
0xe0140000-0xe014007f irq 1
1 at device 8.0 on pci0
de0: SMC 21041 [10Mb/s] pass 1.1
de0: address 00:00:c0:c5:8e:f8

sis0: <NatSemi DP83815 10/100BaseTX> port 0xc4
00-0xc4ff mem 0xe0120000-0xe0120fff irq 12 at device 11.0 on pci0
sis0: Ethernet address: 00:40:f4:60:ad:47
miibus0: <MII bus> on sis0
ukphy0: <Generic IEEE 802.3u media interface> on miibus0
ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto

I don't put the two in the same time in the computer!
vr0 is on miibus1


-- 
regisr

> irq 12 at device 11.0 on pci0
I have mouse on thar irq. What
if you put onother number in
"device.hints"?

                   ZK

> sis0: <NatSemi DP83815 10/100BaseTX> port 0xc4
> 00-0xc4ff mem 0xe0120000-0xe0120fff irq 12 at device 11.0 on pci0
> sis0: Ethernet address: 00:40:f4:60:ad:47
> miibus0: <MII bus> on sis0
> ukphy0: <Generic IEEE 802.3u media interface> on miibus0
> ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
The sis(4) driver had some issues with autoselect in the past.
Just try ifconfig's 'media' option, or update your kernel.

-- 
Cordula's Web. http://www.cordula.ws/

Hmm! I would start with
the simpliest guess. It
is irq number. "dmesg"
will tell all about it.
If you have something
on 12... Your old card
was irq1. (I have keyboard
on it.) If it works as
you wish, try to go to
"/boot/device.hints"
and find something like
"hint.sys.0.irq=12"
and change it to 1. Don't
have it? Write your
lines!
If it doesn't work, it
is time for new letter.

           ZK