Greetings-- I''m trying (and failing...) to get flashboot to work with a PC Engines ALIX 3C2 board. I have flashboot working well on several systems, but this is the first PC Engines board I''ve worked with. When I try to boot using the PCENGINES.bsd from tilde.se, the boot fails like this: ------------------------------------------------------------ PC Engines ALIX.3 v0.99 640 KB Base Memory 261120 KB Extended Memory 01F0 Master 044A CF CARD 1GB Phys C/H/S 1934/16/63 Log C/H/S 967/32/63 Using drive 0, partition 3; Loading;... probing: pc0 com0 pci mem[640K 255M a20=on] disk: hd0>> OpenBSD/i386 BOOT 3.01boot> booting hd0a:/bsd: 24329940+392940 [52+142032+133574]=0x17d7400 entry point at 0x200120 ? ------------------------------------------------------------ I''ve tried compiling my own kernel, with the same result. However, if I do a standard install on a PC with a CF-IDE adapter, I can move the CF card over and it works (serial console output below). Does anyone have a working flashboot kernel config for this board? Or a pointer as to why the boot dies there? Thanks! Frank ------------------------------------------------------------ PC Engines ALIX.3 v0.99 640 KB Base Memory 261120 KB Extended Memory 01F0 Master 044A CF CARD 1GB Phys C/H/S 1934/16/63 Log C/H/S 967/32/63 Using drive 0, partition 3; Loading;... probing: pc0 com0 pci mem[640K 255M a20=on] disk: hd0>> OpenBSD/i386 BOOT 3.01- com0: 38400 baud switching console to???????????????????????????????????????????????????????????????????????????????????? [ using 595232 bytes of bsd ELF symbol table ] Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2008 OpenBSD. All rights reserved. http://www.OpenBSD.org OpenBSD 4.3 (GENERIC) #698: Wed Mar 12 11:07:05 MDT 2008 deraadt at i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC cpu0: Geode(TM) Integrated Processor by AMD PCS ("AuthenticAMD" 586-class) 499 MHz cpu0: FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CFLUSH,MMX real mem = 268009472 (255MB) avail mem = 251097088 (239MB) mainbus0 at root bios0 at mainbus0: AT/286+ BIOS, date 12/10/07, BIOS32 rev. 0 @ 0xfceb2 pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000 pcibios0: pcibios_get_intr_routing - function not supported pcibios0: PCI IRQ Routing information unavailable. pcibios0: PCI bus #0 is the last bus bios0: ROM list: 0xe0000/0xa800 cpu0 at mainbus0 pci0 at mainbus0 bus 0: configuration mode 1 (bios) pchb0 at pci0 dev 1 function 0 "AMD Geode LX" rev 0x31 glxsb0 at pci0 dev 1 function 2 "AMD Geode LX Crypto" rev 0x00: RNG AES vr0 at pci0 dev 9 function 0 "VIA VT6105M RhineIII" rev 0x96: irq 10, address 00:0d:b9:12:83:20 ukphy0 at vr0 phy 1: Generic IEEE 802.3u media interface, rev. 3: OUI 0x004063, model 0x0034 ath0 at pci0 dev 12 function 0 "Atheros AR5212" rev 0x01: irq 9 ath0: AR5213 5.9 phy 4.3 rf5112a 3.6, FCC2A*, address 00:0b:6b:82:83:1b glxpcib0 at pci0 dev 15 function 0 "AMD CS5536 ISA" rev 0x03: rev 0, 32-bit 3579545Hz timer, watchdog, gpio gpio0 at glxpcib0: 32 pins pciide0 at pci0 dev 15 function 2 "AMD CS5536 IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility wd0 at pciide0 channel 0 drive 0: <CF CARD 1GB> wd0: 1-sector PIO, LBA, 951MB, 1949472 sectors wd0(pciide0:0:0): using PIO mode 4, DMA mode 2 pciide0: channel 1 ignored (disabled) ohci0 at pci0 dev 15 function 4 "AMD CS5536 USB" rev 0x02: irq 15, version 1.0, legacy support ehci0 at pci0 dev 15 function 5 "AMD CS5536 USB" rev 0x02: irq 15 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 "AMD EHCI root hub" rev 2.00/1.00 addr 1 isa0 at glxpcib0 isadma0 at isa0 pcppi0 at isa0 port 0x61 midi0 at pcppi0: <PC speaker> spkr0 at pcppi0 npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16 pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo pccom0: console usb1 at ohci0: USB revision 1.0 uhub1 at usb1 "AMD OHCI root hub" rev 1.00/1.00 addr 1 biomask f9ef netmask ffef ttymask ffef mtrr: K6-family MTRR support (2 registers) nvram: invalid checksum softraid0 at root root on wd0a swap on wd0b dump on wd0b clock: unknown CMOS layout Automatic boot in progress: starting file system checks. /dev/rwd0a: file system is clean; not checking setting tty flags starting network DHCPDISCOVER on vr0 to 255.255.255.255 port 67 interval 7 DHCPOFFER from 10.20.30.1 DHCPREQUEST on vr0 to 255.255.255.255 port 67 DHCPACK from 10.20.30.1 bound to 10.20.30.42 -- renewal in 21600 seconds. starting system logger starting initial daemons:. savecore: /dev/wd0b: Device not configured checking quotas: done. building ps databases: kvm dev. clearing /tmp starting pre-securelevel daemons:. setting kernel security level: kern.securelevel: 0 -> 1 creating runtime link editor directory cache. preserving editor files starting network daemons: sendmail inetd sshd. starting local daemons:. standard daemons: cron. Mon Jun 16 13:35:07 CDT 2008 OpenBSD/i386 (alix.awesomenet.net) (tty00) login: