Hi,
I am using xen on F7. My guest config looks like this:
*********************************************
kernel = "/usr/lib/xen/boot/hvmloader"
builder=''hvm''
memory = 512
name = "scp231"
vcpus=2
pae=1
acpi=1
vif = [ ''type=ioemu, bridge=virbr0'' ]
dhcp="off"
disk = [ ''phy:/dev/aida/scp-231,hda,w'',
'',hdc:cdrom,r'' ]
device_model = ''/usr/'' + arch_libdir +
''/xen/bin/qemu-dm''
boot="cda"
vnc=1
vncdisplay=1
vncpasswd=''''
stdvga=0
serial=''pty''
localtime=1
*********************************************
[root@csli9 ~]# /etc/xen/scripts/network-bridge status
===========================================================8: eth2:
<BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue
link/ether 00:30:48:31:97:49 brd ff:ff:ff:ff:ff:ff
inet 172.16.1.37/16 brd 172.16.255.255 scope global eth2
inet6 fe80::230:48ff:fe31:9749/64 scope link
valid_lft forever preferred_lft forever
8: eth2: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue
link/ether 00:30:48:31:97:49 brd ff:ff:ff:ff:ff:ff
inet 172.16.1.37/16 brd 172.16.255.255 scope global eth2
inet6 fe80::230:48ff:fe31:9749/64 scope link
valid_lft forever preferred_lft forever
bridge name bridge id STP enabled interfaces
eth2 8000.003048319749 no peth2
virbr0 8000.3a7b564bbcda no tap0
vif1.0
192.168.122.0/24 dev virbr0 proto kernel scope link src 192.168.122.1
172.16.0.0/16 dev eth2 proto kernel scope link src 172.16.1.37
default via 172.16.1.16 dev eth2
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.122.0 0.0.0.0 255.255.255.0 U 0 0 0
virbr0
172.16.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth2
0.0.0.0 172.16.1.16 0.0.0.0 UG 0 0 0 eth2
===========================================================
[root@csli9 ~]# ifconfig
eth2 Link encap:Ethernet HWaddr 00:30:48:31:97:49
inet addr:172.16.1.37 Bcast:172.16.255.255 Mask:255.255.0.0
inet6 addr: fe80::230:48ff:fe31:9749/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:15230 errors:0 dropped:0 overruns:0 frame:0
TX packets:3692 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:897539 (876.5 KiB) TX bytes:2761958 (2.6 MiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:6171 errors:0 dropped:0 overruns:0 frame:0
TX packets:6171 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:51022608 (48.6 MiB) TX bytes:51022608 (48.6 MiB)
peth2 Link encap:Ethernet HWaddr 00:30:48:31:97:49
inet6 addr: fe80::230:48ff:fe31:9749/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:240988 errors:0 dropped:0 overruns:0 frame:0
TX packets:3730 errors:0 dropped:0 overruns:0 carrier:0
collisions:539 txqueuelen:100
RX bytes:65841255 (62.7 MiB) TX bytes:2780370 (2.6 MiB)
Base address:0x4020 Memory:d8420000-d8440000
tap0 Link encap:Ethernet HWaddr 3A:7B:56:4B:BC:DA
inet6 addr: fe80::387b:56ff:fe4b:bcda/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:110 errors:0 dropped:0 overruns:0 frame:0
TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:500
RX bytes:7544 (7.3 KiB) TX bytes:510 (510.0 b)
vif1.0 Link encap:Ethernet HWaddr FE:FF:FF:FF:FF:FF
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:32
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
virbr0 Link encap:Ethernet HWaddr 3A:7B:56:4B:BC:DA
inet addr:192.168.122.1 Bcast:192.168.122.255 Mask:255.255.255.0
inet6 addr: fe80::200:ff:fe00:0/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:110 errors:0 dropped:0 overruns:0 frame:0
TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:6004 (5.8 KiB) TX bytes:510 (510.0 b)
I would like to use the guest within the subnet of eth2, so 172.16.0.0 .
But it doesn''t work for any reason? It looks like, that I only can use
a
192.168.122.X address in the guest. Any glue how to bridge the interface
to be able access the 172.16.0.0 network directly?
Regards Jonas
--
---------------------------------------------------------------------------
Jonas Weismueller Phone: +49 721 9497-163
COMSOFT GmbH Fax: +49 721 9497-129
Wachhausstrasse 5a http://www.comsoft.de
76227 Karlsruhe, Germany mailto:jonas.weismueller@comsoft.de
Geschäftsführer: Manfred Jlg, Manfred Schmid
Sitz der Gesellschaft: Karlsruhe, Handelsregister: Mannheim HRB 102488
Help save paper - do you really need to print this e-mail?
--- Disclaimer ---
This mail contains private or confidential information for the eyes of the
addressee(s) named within this mail only.
Any distribution or usage, in whole or in part, is strictly prohibited.
If the context of this message indicates that you may have received this mail by
error, please immediately contact and notify
the sender and delete this mail from your computers as well as from your mail
server. Thank you!
---------------------------------------------------------------------------