Fedora xen - Aug 2006 - Experiencing boot problems with xen3

Hi,

I''m trying to install xen3 over a FC5 linux system.
I had downloaded xen3 sources and built them with the following commands:
make world
make install

Then, I added the following lines to grub.conf -

title Xen 3.0
        root (hd0,3)
        kernel /boot/xen-3.0.gz dom0_mem=262144
        module /boot/vmlinuz-2.6-xen0 root=/dev/sda4 ro console=tty0

But I''m getting Error 15: file not found when trying to boot.
I saw that other people got this error as well but I couldn''t resolved
it...

Please advise me on how to solve this problem, I attached grub.conf, the 
output of mount and the dirlist of the /boot directory.

Thanks in advanced,
Eric.

On Thursday 31 August 2006 05:06, Eric Benton wrote:
> Hi,
>
> I''m trying to install xen3 over a FC5 linux system.
> I had downloaded xen3 sources and built them with the following commands:
> make world
> make install
>
> Then, I added the following lines to grub.conf -
>
> title Xen 3.0
>         root (hd0,3)
>         kernel /boot/xen-3.0.gz dom0_mem=262144
>         module /boot/vmlinuz-2.6-xen0 root=/dev/sda4 ro console=tty0
Take the 0 off the end of ''vmlinuz-2.6-xen0''.  That should
work for you.

-Paul Larson

On Thursday 31 August 2006 13:05, you wrote:
> Eric Benton wrote:
> > Paul Larson wrote:
> >> On Thursday 31 August 2006 09:00, you wrote:
> >>> Yes thank you,
> >>> I did that, but when booting the xen kernel it paniced, now
I''m trying
> >>> to build Xen with VT support -> any suggestions on that?
> >>
> >> What was the panic?  I noticed that you aren''t including
an initrd.
> >> Depending on what kind of panic you got, that may be the source of
> >> your problem (not compiling some things in that needed to be
there,
> >> and not including initrd).
> >>
> >> With Fedora, you''re probably better off biting the bullet
and just
> >> always building an initrd for it.  It''ll likely save you
a lot of
> >> headaches later.
> >>
> >> -Paul Larson
> >
> > Hi Paul,
> > I did what you said and I''m currently writing this email
after
> > successfully booting from the xen kernel.
> >
> > Thanks for your help!
> > Eric.
>
> Hi Again,
>
> During boot time (which succeeds at the end) there are couple of errors:
> 1. auditd fails to start
> 2. a lot of python import errors are shown from the xen site package
>
> Do you know what might cause those errors please?
I haven''t seen that with FC6-test2 or rawhide, though I
haven''t looked at
Rawhide in a while.  What are you testing on, and what changes did you make 
when you rebuilt xen?

-Paul Larson